aube TH209 Non-Programmable Thermostat User Guide

Owner’s Guide

TH209
Non-programmable Thermostat

Do you need assistance?
We are here to help.
For assistance with this product please call
Customer Care toll-free at
1-800-468-1502.

OWNER’S GUIDE

About Your New Thermostat

This thermostat can be used to control an electric heating system such as a baseboard heater or a convector.
The thermostat CANNOT be used with:

•  a resistive load under 0.83 A
• a resistive load over 8.3 A
•  a system driven by a contractor or a relay (inductive load)
•  a fan-forced heating system (e.g.: fan-forced convector)
•  a central heating system

SUPPLIED PARTS

• One (1) thermostat
•  Two (2) 6-32 mounting screws
•  Two (2) solderless connectors

Temperature Display and Setting

The thermostat normally displays the actual (ambient) temperature.

• To view the setpoint temperature, briefly press the Up or Down button. The setpointwill be displayed for 5 seconds.
• To change the setpoint temperature, press the Up or Down button until the desired value is displayed.

Removing the Faceplate

TURN OFF THE POWER OF THE HEATING SYSTEM AT THE MAIN POWER PANEL TO AVOID ELECTRIC SHOCK.

Loosen the screw holding the faceplate to the base. The screw cannot be completely removed and remains captive on the base. Remove the faceplate from the base by pulling the bottom half.

Wiring

Connect either one of the thermostat wires to the heater wire and the other one to the power supply wire using solderless connectors for copper wires.

NOTE: All cables and connections must conform to the local electrical code. Special CO/ALR solderless connectors must be used when connecting with aluminum conductors.

Installing the Faceplate

Install the base onto an electrical box. Reinstall the faceplate on the base and secure it in place with the screw.

NOTE: Keep the air vents of the thermostat clean and unobstructed at all times.

Selecting the Temperature Display Format

To select the temperature display format:

1. Press the Up and Down buttons for three seconds. The format currently used will be indicated on the screen.
2. Press the Up or Down button to change the format.
3. Press the Up and Down buttons for one second (or wait for one minute) to return to the normal display.

Table 1. In Case of Difficulty

Specifications

Supply: 120/208/240 VAC, 50/60 Hz
Minimum load:
0.83 A (resistive only)
200 W @ 240 VAC
100 W @ 120 VAC
Maximum load:
8.3 A (resistive only)
2000 W @ 240 VAC
1000 W @ 120 VAC
Display range: 0°C to 50°C (32°F to 99°F)
Setpoint range: 5°C to 30°C (40°F to 85°F)
Storage: -20°C to 50°C (-4°F to 120°F)
Permanent memory:
You do not need to adjust the temperature following a power outage.
ICES-3 Class B Notice: This Class B digital apparatus complies with
Canadian ICES-3.

3-Year Limited Warranty

Resideo warrants this product to be free from defects in workmanship or materials, under normal use and service, for a period of three (3) years from the date of first purchase by the original purchaser. If at any time during the warranty period the product is determined to be defective due to workmanship or materials, Resideo shall repair or replace it (at Resideo’s option).
If the product is defective,
(i) return it, with a bill of sale or other dated proof of purchase, to the place from which you purchased it; or (ii) call Resideo Customer Care at 1-800-468-1502. Customer Care will make the determination whether the product should be returned to the following address: Resideo Return Goods, Dock 4 MN10-3860, 1985 Douglas Dr. N., Golden Valley, MN 55422, or whether a replacement product can be sent to you.
This warranty does not cover removal or reinstallation costs. This warranty shall not apply if it is shown by Resideo that the defect was caused by damage which occurred while the product was in the possession of a consumer.

Resideo’s sole responsibility shall be to repair or replace the product within the terms stated above. RESIDEO SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND, INCLUDING ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES  RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WARRANTY, EXPRESS OR IMPLIED, OR ANY OTHER FAILURE OF THIS PRODUCT. Some states do not allow the exclusion or limitation of incidental or consequential damages, so this limitation may not apply to you.
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY RESIDE MAKES ON THIS PRODUCT. THE DURATION OF ANY IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED TO THE THREE-YEAR DURATION OF THIS WARRANTY. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may have other rights which vary from state to state. If you have any questions concerning this warranty, please write Resideo Customer Care, 1985 Douglas Dr, Golden Valley, MN 55422 or call 1-800-468-1502.

CAUTION: ELECTRONIC WASTE NOTICE

The product should not be disposed of with other household waste. Check for the nearest authorized collection centers or authorized recyclers. The correct disposal of end-of-life equipment will help prevent negative consequences for the environment and human health.

Resideo Technologies, Inc.
1985 Douglas Drive North, Golden Valley, MN 55422
1-800-468-1502
69-2771EF—07 M.S. Rev. 01-21 | Printed in the United States
www.resideo.com

© 2020 Resideo Technologies, Inc. All rights reserved.
This product is manufactured by Resideo Technologies, Inc. and its affiliates.

Documents / Resources

aube TH209 Non-Programmable Thermostat [pdf] User Guide TH209, Non-Programmable Thermostat