CHA 8188 Dorchester Club Table Lamp
Product Information
The Dorchester Club Table Lamp, item #CHA 8188, is a light
fixture that requires assembly before use. The lamp does not come
with a bulb included. It is important to follow all applicable
local installation codes and have knowledge of the construction and
operation of the lamp.
Please inspect the lamp and its contents carefully before
installation. If any damage or defects are found, do not proceed
with installation. Retain all packaging material until the
installation is complete and approved.
Tools required for assembly (not included): scissors.
Product Usage Instructions
- Carefully remove all parts from the box and place them on a
clean, soft surface. - Thread the shade riser (B) onto the top of the cluster
(C). - Remove the finial (A) from the shade riser (B).
- Remove the shade (H) from its packaging and install it onto the
shade riser (B) using the finial (A). If the shade has additional
packaging, carefully cut it off from the interior of the shade to
avoid damages. - Install a light bulb into the socket.
- Loosen the check ring (E) to adjust the rod (D) to the desired
height, then tighten the check ring (E). - Remove the protective cover (G) from the plug (F).
- Plug the lamp into an electrical outlet and test the
fixture.
Care Instructions
To clean the lamp, use only a soft dry cloth or feather duster.
Do not use abrasive or chemical agents.
This product is listed and approved for use in the United
States (US).
ASSEMBLY INSTRUCTIONS
Bulb not included
A H (Packaged separately)
B C
D E FG
Dorchester Club Table Lamp Item # CHA 8188
NOTICE: This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED): Scissors
1. Carefully remove all parts from the box. Place on a clean, soft surface. 2. Thread shade riser (B) to the top of cluster (c). 3. Remove finial (A) from shade riser (B). 4. Remove shade (H) from packaging and install to shade riser (B) using
finial (A). NOTE: If shade has additional packaging, carefully cut off from interior of shade to avoid damages. 5. Install light bulb into the socket. 6. Loosen check ring (E) to adjust rod (D) to desired height, then tighten check ring (E). 7. Remove protective cover (G) from plug (F). 8. Plug into electrical outlet and test fixture.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
M
L IST ED
US
