Lite-on Wpx8324 Led Wifi Router Owner's Manual

WPX8324 LED WiFi Router

Product Information:

The WPX8324 is a wireless access point (AP) with dimensions of
150mm x 210mm x 105mm. It features LED indicators to provide status
information.

The LED descriptions are as follows:

Product Usage Instructions:

1. Getting AP online:
   1. Step 1: Power up the AP using PoE. Plug one
      end of the Ethernet cable into the PoE switch or injector, and plug
      the other end into the LAN1(PoE) port.
   2. Step 2: Connect the PoE switch or injector to
      your LAN network with Internet access.
   3. Step 3: Check the LED status. Wait for a few
      minutes until the Power LED turns solid Green and LAN1 LED turns
      Blinking. This indicates that the AP is online and ready for
      operation.
2. Troubleshooting:

   If the AP fails to connect to the cloud server, please check the
   following:

   1. Ensure that the Ethernet cable is plugged into the LAN1(PoE)
      port, and LAN1 LED is NOT OFF.
   2. If the AP fails to get a valid IP address from the local DHCP
      server, ensure that the DHCP service is ENABLED on your
      router.
   3. Ensure there is Internet connectivity on the local LAN network
      to which the AP is connected.

210mm 105mm

150mm

Troubleshooting The following table shows the status of the AP’s LED indicators.

WPX8324 LED Descriptions

LED

Color Status

Indicative

Power Green Solid Light

Light off

2.4G

Green Solid Light

Blinking

Light off

5G

Green Solid Light

Blinking

Light off

LAN1 Green Solid Light

(PoE in)

Blinking

Light off

LAN2 Green Solid Light

Blinking Light off

Description
Power on Power off Connect to WLAN port WLAN activity present No activity or power off Connect to WLAN port WLAN activity present No activity or power off Device connected to LAN port at 10/100/1000Mbps LAN Activity present Not Connected Device connected to LAN port at 10/100/1000Mbps LAN/WAN Activity present Not Connected

If the AP fails to connect to the cloud server, please check the following: 1. Ensure that the Ethernet cable is plugged into the LAN 1(PoE) port, and LAN1
LED is NOT OFF. 2. If the AP fails to get a valid IP address from the local DHCP server, ensure that the
DHCP service is ENABLED on your router. 3. Ensure there is Internet connectivity on the local LAN network to which the AP is
connected

Getting AP online

Step 1: Power up Using PoE, plug one end of the Ethernet cable into the PoE switch or injector and plug the other end into the LAN 1(PoE) port. Step 2: Connect to the network Make sure the PoE switch or injector is connected to your LAN network with Internet access.

( ): 100g ( ):Black ( ): NO ( ):150*210mm ( ):+-1mm

8*3%$

Step 3: Check the LED status Wait for a few minutes until the Power LED turns solid Green and LAN1 LED turns Blinking. The AP is then online for operation.

75mm

for WPX8324

QSG

515000060147

A0

Dereck
2022-05-10