US6581N Stand-Up Weed Puller
User Manual
Assembly Instructions
STEP 1: Remove all hardware from the package. This should include two long bolts, two small screws, four washers, and two Allen keys as pictured.
STEP 2: Remove and discard the black plug from the bottom section of the Weed Puller (this is there for shipping purposes only).
STEP 3: Push the top handle into the base of the Weed Puller. Please note, this will only attach in one direction.
STEP 4: Place one washer over the long bolt and push through one side of the fixture hole. Place a washer over one small screw and insert it into the other side of the bolt. Tighten with the two Allen keys simultaneously.
STEP 5: Repeat the process for the remaining hole. Now you are ready to get the wedding!
Instructions
STEP 1: Place the claw over the center of the weed. This is important as you want to remove the entire root.
STEP 2: Press down on the foot peddle until it is level with the grass.
STEP 3: Pull the Weed Puller away from the weed onto the foot peddle. This will close the claw around the weed.
STEP 4: Continue to lean the handle of the Weed Puller back until the weed has lifted from the ground.
STEP 5: Hold the green rubber grip on the handle and push down to open the claw and eject the weed. 
Model: US6581N
Stand-up Weed Puller
TIP Rinse or wipe the claws clean after use to prevent any dirt from building up inside the mechanism.
For more information visit hoselink.com
or call
+1 (833)216-4673
Cultivating Connections
