LUCI TABLE
USER GUIDE
CONTENTS
A. USB CHARGING CABLE
B. LAMP HEAD
C. LAMP BODY
D. STABILITY PLATE
ASSEMBLY
REMOVE ALL COMPONENTS FROM INDIVIDUAL PACKAGING AND JOIN IN ORDER DEMONSTRATED HERE. NOTE: STABILITY PLATE IS OPTIONAL.
FUNCTION
| STANDBY BATTERY LOW (BELOW 20%) CHARGING (0-90%) CHARGING (90-100% COMPLETE) | OFF ON FLASHING SLOWLY ON |
CONTENTS
A. UPPER POST SECTION
B. LOWER POST SECTION
C. LAMP HEAD
D. LAMP BASE
E. POWER SUPPLY UNIT
(GLOBAL PIN ADAPTERS INCLUDED)
ASSEMBLY
FUNCTION
SPECIFICATIONS
LED Flat Panel
(2700K-2200K) Warm Dim
5.3 Watt
350 Lumens
11-110 hr battery life
5 hr charge time (using provided 24W power adapter)
This device complied with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Caution: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
- This device must not cause interference
- This device must accept any interference, including interference that may cause undesired operation of thie device.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is not guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
[email protected]
[email protected]
888 MARIN ST
SAN FRANCISCO, CA 94124
PABLODESIGNS.COM
PABLODESIGNS.EU
[email protected]
888 MARIN STREET SAN FRANCISCO. CA 94124
PABLODESIGNS.COM 
Pablo
