BELMONT Floor and Table Lamp

Product Information

• Bulb Types:
  • 2X BT-15 72W (120V) Halogen or LED
  • OR 2X A19 9.5W (120V) LED
• Length of Cord Supplied: 9ft (274cm)
• Care Instructions:
  • To remove dust and small debris: Clean with a soft hair brush
    or use a vacuum.
  • To remove other substances: Use a damp cloth and, if needed, a
    mild detergent. Avoid ammonia-based cleaners.

Product Usage Instructions

1. Assembly Instructions:
   1. Top Diffuser Shade Assembly
   2. Socket Assembly Bottom Diffuser
   3. Belmont Floor Assembly
      1. Attach the legs to the base of the lamp.

Contact Information:

Email: [email protected]

Address: 888 Marin Street, San Francisco, CA 94124

Website: www.pablodesigns.com

BULB TYPES 2X BT-15 72W (120V) HALOGEN OR LED
OR 2X A19 9.5W (120V) LED
LENGTH OF CORD SUPPLIED 9FT (274CM)
CARE INSTRUCTIONS
TO REMOVE DUST AND SMALL DEBRIS: CLEAN WITH A SOFT HAIR BRUSH OR USE A VACUUM. TO REMOVE OTHER SUBSTANCES: USE A DAMP CLOTH AND IF NEEDED A MILD DETERGENT. AVOID AMMONIA BASED CLEANERS

BELMONT
FLOOR
ASSEMBLY INSTRUCTIONS AND USER GUIDE

[email protected] 888 MARIN STREET SAN FRANCISCO, CA 94124
PABLODESIGNS.COM

BELMONT FLOOR

ASSEMBLY

TOP DIFFUSER

SHADE ASSEMBLY

SOCKET ASSEMBLY BOTTOM DIFFUSER

BELMONT FLOOR

ASSEMBLY

1.

2.

3.

4.

LEGS

5.

6.

1. ASSEMBLE LEGS (3 LOWER SECTIONS AND 3 UPPER SECTIONS). 2. ATTACH LEGS TO SOCKET ASSEMBLY (NOTE! REAR LEG INDICATED BY CABLE CLIP). 3. INSERT LOWER DIFFUSER VERTICALLY, ONCE INSIDE, ROTATE UNTIL FROSTED SIDE IS FACING DOWN AND DROP INTO PLACE MAKING SURE IT NESTS PROPERLY. 4. REMOVE 4X SCREWS IN TOP OF SOCKET ASSEMBLY. SLIP SHADE OVER SOCKET ASSEMBLY AND ATTACH WITH PROVIDED SCREWS (NOTE! LOGO TAG FACES REAR OF LAMP). 5. INSTALL BULBS (PROVIDED) 6. LOAD UPPER DIFFUSER WITH FROSTED SIDE UP AND SECURE CABLE INTO CABLE CLIP TO COMPLETE.
pg. 1

pg. 2

References

• Pablo