Nissan Versa Fuse Box Diagram

The fuse box is located on the driver’s side of the instrument panel, behind the cover.

The fuse box cover is held in place by two screws. You can remove the screws with a T-20 Torx screwdriver.

The cover is held in place by two screws. Remove the screws and lift up the cover to access the fuses.

With the fuse box cover removed, you can easily access and replace a blown fuse. Just be sure to use the correct amperage replacement.

Remove the fuse from its holder. In some cases you may need a small screwdriver to unscrew the fuse holder cap. Look at the fuse wire. If there is a visible gap in the wire or a dark or metallic smear inside the glass then the fuse is blown and needs to be replaced.

Remove Cover – Locate engine fuse box and remove cover.
Locate Bad Fuse – Find the fuse that is tied to the bad component.
Remove Fuse – Take out the fuse in question and assess if blown.
Replace Cover – Secure the cover and test component.
More Info. –

3. Electrical Glitches. Electrical glitches in your car and car battery may be caused by factors such as poor installation, faulty fuses, and flawed wiring. These electrical glitches can result in the normal and expected parasitic drains on your car battery becoming excessive and drain the battery when the car is .

The interior fuse box is on the driver’s lower left side. To remove the fuse box lid, pull it toward you and take it out of its hinges. The under-hood fuse box is located near the back of the engine compart- ment on the driver’s side.

Before you start working on any automotive project, it’s important that you turn off the engine and disconnect the battery, especially before doing any electrical work. Any misstep with automotive wiring while the battery is hooked up could cause further damage and potentially give you an unpleasant zap.

The interior fuse box is underneath the steering column. The under-hood fuse box is in the engine compartment next to the battery.

First, open the hood and start the car. While the engine is running, remove the negative cable from the battery. If the vehicle stalls or dies, the alternator is likely bad. This happens because the alternator is not generating enough electricity to keep the engine running on its own

If one bulb is working but not the other, the problem is not the fuse. Fuses should last for years. If you’re having problems with your car’s lightbulb fuses blowing frequently, there’s definitely an electrical problem present and you should have it inspected and diagnosed immediately by a professional mechanic.

The instrument panel fuse box is usually located inside the vehicle, and usually on the driver’s side. There should be a diagram inside the fuse box (or in the owner’s manual) that shows you what each fuse powers.

The fuses and relays are usually identified on the inside of the power center cover.

If the dashboard lights aren’t working at all, a blown fuse may be the culprit. It’s relatively easy to remove and replace a fuse that has been damaged; however, if the fuse blows again, it could be indicative of a deeper electrical problem that a professional will need to address

If the dashboard isn’t lighting up at all, your car might have blown a fuse. Removing the old fuse and replacing it should get the lights working again. While the new fuse may do the trick, it could also indicate a deeper electrical problem.

A fuse is a one time protection device that can interrupt a circuit. A relay is a device that is used to connect or interrupt the circuit.

fuse-box.info