Mpow Auto-lock Wireless Car Charger Mount User Manual (+ PDF)

AUTO-LOCK WIRELESS CAR CHARGER MOUNT
MPOW CAR PHONE MOUNT

Contents hide

7 Documents / Resources

7.1 References

8 Related Posts

Package

Working Process

A. Power Indicator
B. Precise Alignment

C. Extendable Arms
1. Tap the Release Button on either side and the arms will open automatically.
2. Once the phone is in, the arms will lock automatically.
3. After removing the phone, tap the Release Button on either side and the arms will close automatically.

D. Charging

Charging/Fast Charging: Red light stays on

Error: FOD (Foreign Object Detection)/overvoltage protection/overtemperature protection/overcurrent protection

Assembly

Installation

1. Make sure the clip is in the loosened state.
2. Insert the clip into the air vent louvers.
3. Toggle the lock lever to ﬁx.
4. Adjust the angle by rotating the 360° ball joint.

Notiﬁcation

1. Not recommended to install the mount on rough, dirty, and curved surfaces.
2. The wireless charger only works with phones that support wireless charging.
3. When using the QC2.0/QC3.0 car charger, the charging efficiency can reach 7.5W or 10W.
4. Please adjust the support foot to properly align your phone and ﬁx it ﬁrmly.
5. With over-temperature protection, the product may stop working if the temperature exceeds 50°C.
6. Do not expose it to direct sunlight for a long time, as high temperatures will weaken the suction cup.
7. To renew the stickiness of the suction cup, just rinse it with water and let it air dry.
8. Please use an adapter of 5V 2A or above for normal wireless charging.

FCC Statement

Any Changes or modiﬁcations not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.