DOM Tronic Slim Keypads
Tronic Slim Product Information and Usage Instructions
Product Information
The Tronic Slim is a product that comes with right and left hand
doors and accessories that are required for assembly. The product
also comes with a drilling template to assist with installation.
The doors are assembled separately, and there are specific warnings
that must be followed during the assembly process.
Usage Instructions
Before starting the assembly process, ensure that the cable is
properly connected and that no keys are pushed during the wire
assembly process. The batteries must be released using the T20 Torx
Security screw located on the opposite side of the battery case.
Ensure that the batteries are in the correct polarity as indicated
in the battery box. It is important to note that the battery pack
must remain connected during the release of the batteries;
otherwise, the internal clock will lose the time configuration.
To assemble the right-hand door, use the drilling template to
drill a hole using a 2.5 drill bit. Then, follow the steps in
section A-A to assemble the right-hand door. Ensure that you
connect the blue part to the side of the ledge as indicated in step
4. Repeat these steps for the left-hand door assembly.
During assembly, verify that the screws are not fastened too
tight, as indicated in assembly step 3. Failure to follow this
warning could result in damage to the product.
Tronic Slim
Assembly
Drilling template
ASSEMBLY
Right hand door
TRONIC SLIM : Drilling t
2,5
ø8,1
ø4,5 For housing the screw head
TRONIC SLIM : Drilling template
Left hand door
2,5
ø8,1
ø4,5 For housing the screw head
Accessories
ASSEMBLY
C ø5×29.5 E ø3.5×9.5 F Strike plate D M3x18
Right door assembly
ASSEMBLY
A
A
A
18 mm
x mm
1
2
18 + x mm
Section A-A
ø3.5 ø22
Right door assembly
ASSEMBLY
3
4
Right door
! Warning: Connect blue part to the side of the legde
5
6
Right door
Left door assembly
ASSEMBLY
A
A
B
1 B
Section A-A
2
ø3.5 ø22
18 mm x mm B
Left door assembly
ASSEMBLY
3
4
Left door 5
! Warning: Connect blue part to the side of the legde
6
Left door
1
Verify that the cable is properly
Don’t push any key during the wire
connected (straight and untill
assembly process.
the bottom).
2
Relase the batteries thanks to
T20 Torx Security screw located
on the opposite of the battery case
Verify that the batteries are in the right polarity (as indicated in the battery box).
IMPORTANT The battery pack must remain connected during the release of the batteries. Otherwise, the internal clock will lose the time configuration.
Important notes
ASSEMBLY 3
Verify that the screws are not fastened too tight (<20kgf/cm2). 4
Verify that the latch works smoothly in and out, without any frinction with the door frame.
Batteries
ASSEMBLY
If the yellow LED blinks Dead batteries: replace batteries.
1. Make sure the battery pack contains full powered batteries (don’t screw the battery pack too tight to avoid breaking the mechanism). make sure to use the USB-C adaptor.
2. If the lock is closed, introduce the user code (or the master one) to open it.
3. Replace the old batteries for new ones and disconnect the battery pack.
Important
We suggest to change once every three years the batteries for ensure their good condition. After a long time, the batteries can deteriorate
and damage the lock, especially in hot environments
Do not clean the locks with cleaning
products with hydrochloric acid, lye or corrosive components, especially on the metallic parts.
