NP08001SE 8oz Popcorn Machine
Product Information:
POPCORN MACHINE
This popcorn machine is an 8oz popcorn maker that comes with a
storage compartment for utensils and non-perishable ingredients.
The machine is rated at 120 volt and has 3 function switches: spot
light and warmer, stirrer, and stainless steel pot heater. The
kettle should be secured onto the hanger of the main unit before
plugging in the power cord. The machine should be preheated for 3
to 4 minutes with oil before adding plain popcorn kernels.
Product Usage Instructions:
- Make sure the popcorn maker is unplugged before performing any
of the following steps. - Plug the unit into a 120-volt power source to avoid potential
damage to the unit. - Clean the internal surface of the kettle pot and main unit
surfaces. - Use the main unit’s three function switches as follows: spot
light and warmer (1), stirrer (2), and stainless steel pot heater
(3). - Secure the kettle onto the hanger of the main unit.
- Plug in the power cord to the popcorn maker.
- Switch on the light and heater (1 & 3) and fill the kettle
with the correct amount of oil based on popping chart in Figure 5.
Do not use butter inside the kettle, as it will burn. - Preheat the kettle for 3 to 4 minutes with oil until steam
rises from the pot. - Measure out the corresponding amount of plain popcorn kernels
from the chart in Figure 5. Use plain popcorn kernels with no
seasoning or salt, as it will cause oil to splatter. - Lift the lid and carefully pour in the kernels.
- Switch on the stirrer switch (2).
- Shut the door carefully.
- Popcorn starts popping out through the lid after about 2 to 3
minutes. - Switch off the stirrer and heater switches (2 & 3) when
popping is complete (no more popping sounds from the pot). - Rotate the handle on the kettle counterclockwise to pour out
all remaining popcorn from the kettle. Caution: The kettle will be
hot! - Keep the heater switch (3) off if the unit is not being
continuously used. - Serve your popcorn with the popcorn scoop provided.
- Remove the plug from the power supply if the unit is not being
used for a long period of time. - Repeat steps 7 to 12 for continuous popping.
Cleaning and Maintenance: Never immerse the
kettle into water.
POPCORN MACHINE
8oz Popcorn Mahicne Manual
2
NP08001SE 3
4
USING YOUR POPCORN MAKER
TIP: The popcorn maker comes with a handy storage compartment. It is a convenient way for you to store any utensils or non-perishable ingredients right along with your popcorn maker. You will always be prepared and well equipped to make hot, fresh popcorn anytime.
1) Make sure the popcorn maker is unplugged before you do any of the following. 2) Popcorn Maker is rated at 120 volt. Only plug unit into 120 volt power source to avoid potential
damage to unit. 3) Clean the internal surface of the kettle pot and main unit surfaces. 4) Main unit has 3 function switches as follows:
Spot light and warmer
(1)
Stirrer
(2)
Stainless steel Pot heater
(3)
5) Secure the kettle onto the hanger of the main unit.
6) Now you can plug in the power cord to the popcorn maker.
7) Switch on the light and heater (1 & 3) and fill the kettle with the correct amount of oil (Figure 1)
based on popping chart in Figure 5.Do not use butter inside the kettle. Butter will burn.
8) Kettle should be pre-heated for 3 to 4 minutes with oil (until steam rises from the pot).
9) Measure out corresponding amount of plain popcorn kernels from the chart in Figure 5. Make
sure to use plain popcorn kernels with no seasoning or salt as it will cause oil to splatter.
10) Lift the lid and then pour in the kernels carefully.
(Fig.2) Caution: Lid will be HOT!
Figur e 5
11) Switch ON the Stirrer switch (2). F(ig.3)
12) Shut the door carefully.
OIL
POPCORN
13) Popcorn starts popping out through the lid after about 2 to 3 minutes. F(ig.4)
14) Switch OFF the stirrer & heater switches (2 & 3)
1 Tbsp 1.5 Tbsp
Cup Cup
when popping is complete (No more popping
sounds from the pot). 15) Rotate handle on kettle counter clockwise to pour
2 Tbsp
1 Cup
Do not exceed 1-cup per batch
out all remaining popcorn from kettle. CAUTION: Kettle will be HOT!
16) Keep heater switch (3) OFF if the unit is not being continuously used.
17) Serve your popcorn with popcorn scoop provided.
18) Remove plug from power supply if the unit is not being used for a long period of time.
19) Repeat step 7 to 12 for continuous popping.
5
F ig.1 F ig. 3
F ig. 2 F ig. 4
Cleaning and Maintenance
To avoid burning of excess oils on the bottom of the kettle,frequent cleaning is strongly recommended. – Let unit cool down before cleaning. – Use wet towel to clean the kettle surface inside and out. – With a clean damp cloth, wipe down the glass,acrylic doors and metal surfaces. – Do not use any acidic,citrus based cleaners or abrasive cleaners on the Acrylic doors as it may scratch or become dull. – Frequently empty the catch tray of old popcorn kernels and clean with soap and water and dry thoroughly. Additional Cleaning r ecommendations – Complete basic cleaning as instructed above. – To thoroughly clean the kettle,turn off the unit and add 1-1/2 to 2 cups of hot water (no detergent is necessary) into the kettle. Turn ON the stirrer and the heater and bring water to boil for 1 to 2 minutes. Place a towel in the bottom of the unit with a large bowl on top (make sure bowl is large enough to pour out the water from the kettle). Turn off stirrer and heater and carefully pour out water into bowl. CAUTION: Kett le and water will be HOT! – Repeat same procedure 2 to 3 times for best results.
Never immerse the kett le into water
6
