Hollyland Lark C1 Wireless Transmitter User Manual

Lark C1 Wireless Transmitter
User Manual

LARK Cl
” The quantity is based on the product’s various models and is subject to the actual quantity of equipment purchased.

PACKING LIST

LARK C1 SOLO (TX*1 to RX*1) Wireless Microphone System
The quantity is based on the product’s various models and is subject to the actual quantity of equipment purchased.
LARK DUO (1)(“2 to RX*1) Wireless Microphone System with Charging Case
The quantity is based on the product’s various models and is subject to the actual quantity of equipment purchased.

PRODUCTION INFORMATION

PRODUCTION INSTALLATION

1. The TX (transmitter) automatically turns on when takes it out from the charging case. Simply dip the TX (transmitter) to a shirt collar.
2. Connect the W to the smartphone;
3. Change the Smartphone via the FCC

PRODUCTION FUNCTION

Noise Cancellation Function

• Blue LED Stays On: The device disconnected HearClear(Noise Reduction) Off by default
• Green LED Stay 011: HeaClear(NOiee Reduction) ON Press the Ws yLlbee oxen so tun on re HeaCI-anNoiee Saaxecn) Knebel. Wrist” actual Ma newt LED turns gee’.

Noise cancellation FunctionCharging Case Battery Level

• LED Flashing: Charging Flashing
• Two Lights Flashing,V50%
• Three Lights Flashing MMMM75%
• I Pow Lights Flashing  100%
• 4,41

Manual FusionAfter the receiver is connected to the smartphone, long press TX’S tio/a: button for 3s and then long press FtX’s for 3s Paid%
” The device has been paired in the factory before shipping. The product needs to pair again when there is a disconnection.

PARAMETERS

SUPPORT

If any problems are encountered using the product, please follow these options for receiving technical support:

Hdlyland Products User Group
HdlylandTech
HdlylandTech
[email protected]
www.holMand-tech.com

Note: The frequency range and wireless transmit power of the device vary based on the regulations of different countries and regions.

Safety Precautions

Do not place the product near or Inside heating devices (including but not limited to microwave ovens, induction cookers, electric ovens, electric heaters, pressure cookers, water heaters, and gas stoves) to prevent the battery from overheating and exploding. Never use non-original charging cases, cables, and batteries with the product. The use of non-original spare parts may cause electric shock, fire, explosion, or other dangers.

FCC Requirement

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1 }this device may not cause harmful interference. (2)this device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
The device has been tested and complies with FCC SAR limits.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference In a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radionic technician for help.