KW5722ABALB Ophelion Medium Pendant
Installation Guide
ASSEMBLY INSTRUCTIONS
Ophelion Medium Pendant
Item # KW 5722
NOTICE:
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
| Phillips Screwdriver Wire Strippers | Slotted Screwdriver Slip-joint pliers | Wire Cutters |
PERSONS REQUIRED: Two
- Carefully remove all parts from the box. Place on a clean, soft surface.
- Remove mounting plate (C) from canopy (G) by removing collar ring (H).
- Remove mounting bracket (O) from mounting plate (C) by removing screws (N).
- It is recommended to install a 1/4 IPS threaded pipe, secured to a structural member of the building (not included). Then install threaded nipple (B) into receiver and tighten with wrench.
NOTE: Item must be supported independent of the junction box due to weight. - Install mounting plate (C) to mounting bracket (O) and secure with screws (N).
NOTE: It is recommended to have a helper assist in supporting the fixture for steps 6-10. - Install alabaster shades (M) to fixture (K) by securing with screws (L).
- Feed electrical and ground wire through bottom rod (J) and connect to fixture (K).
- Continue feeding wires through collar ring (H), canopy (G) and top rod (I).
