2795-695 Auresa 5 Light Soft Brass Globe Pendant Light
Product Information
The product is a ceiling fixture, item number 2795-695, with a
circular strap and a glass cover. The fixture requires five
candelabra (T8) bulbs, up to 40 watts each. The installation manual
was last updated in April 2022.
Product Usage Instructions
- Shut off power at the fuse box or circuit breaker and remove
the old fixture including the mounting hardware. - Carefully unpack your new fixture and lay out all the parts on
a clean area. Take care not to lose any small parts necessary for
installation. - Thread screws (B) into pre-drilled holes on circular strap (G)
spaced same distance apart as holes in canopy (J) and tighten with
nuts (E). The length of screws (B) may be adjusted if
necessary. - Attach circular strap (G) to junction box (not included) using
mounting screws (D). The side of circular strap marked GND must
face out. - Determine desired hanging height and thread rods (I2, and I1)
to all thread of fixture’s body. Then secure canopy (J) to rod
(I1). Pass wires carefully through each rod and canopy (J) as you
assemble. - Connect the electrical wires as shown in Fig.2, making sure
that all wire connectors (C) are secured. If your junction box has
a ground wire (green or bare copper), connect the fixture’s ground
wire to it. Otherwise, connect the fixture’s ground wire directly
to the circular strap (G) using the green screw provided. - Tuck wire connectors neatly into the junction box.
- Place canopy (J) over screws (B) and secure with finials
(A). - Install (5) five candelabra (T8) bulbs (not included) up to 40
watts each in accordance with the fixture specification–DO NOT
EXCEED THE MAXIMUM WATTAGE RATING! - Screw glass (H) onto fixture (F). Don’t over tighten.
- Return power to the junction box and test the fixture.
INSTALLATION INSTRUCTIONS
Item#2795-695 (New. 04/15/2022)
READ AND SAVE THESE INSTRUCTIONS
WARN I N G ! SH UT POWE R OF F AT FUS E OR CI RC U IT BRE AKE R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
MOUNTING THE FIXTURE (Fig.1) 1. Shut off power at the fuse box or circuit breaker and remove
the old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts on
Fig.1
Set# A-021 -Circular Strap
a clean area. Take care not to lose any small parts necessary
-Ground Screw
for installation.
-Mounting Screw*2
3. Thread screws (B) into pre-drilled holes on circular strap (G)
spaced same distance apart as holes in canopy (J) and
tighten with nuts (E). The length of screws (B) may be
adjusted if necessary.
E
4. Attach circular strap (G) to junction box (not included) using
mounting screws (D). The side of circular strap marked “GND”
B
must face out.
5. Determine desired hanging height and thread rods (I2, and I1) to all thread of fixture’s body. Then secure canopy (J) to
J
rod (I1). Pass wires carefully through each rod and canopy (J)
A
as you assemble.
CONNECTING THE WIRES (Fig.2)
6. Connect the electrical wires as shown in Fig.2, making sure
that all wire connectors (C) are secured. If your junction box
I2
has a ground wire (green or bare copper), connect the fixture’s H
ground wire to it. Otherwise, connect the fixture’s ground wire
directly to the circular strap (G) using the green screw
provided.
Rod I1# W30-H-695 Rod I2# W30-1-695
C G D
I1
7. Tuck wire connectors neatly into the junction box.
FINISHING THE INSTALLATION (Fig.1)
F
8. Place canopy (J) over screws (B) and secure with finials (A).
9. Install (5) five candelabra (T8) bulbs (not included) up to 40
watts each (not included) in accordance with the fixture
specification–DO NOT EXCEED THE MAXIMUM
WATTAGE RATING! (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!).
10. Screw glass (H) onto fixture (F). Don’t over tighten.
Your installation is now complete. Return power to the
junction box and test the fixture.
Note: Illustration (Fig.1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
Fig.2
URE
FIXT WIRE SBlack or Smooth
FIXTURE WIRES White or Ribbed
FIXTURE
WGrIeReEnSor Bare Copper (Ground)
USE ES
HO WIR B(Hlaoct)k
WHIORUESSE White (Neutral)
HOUSE WIRES Green (Ground)
2795-695
