WP-150 Ultra Plus Water Flosser
Product Information:
The WP-150 Series is a water flosser device manufactured by
Waterpik. It is designed to provide efficient and effective oral
hygiene by utilizing a combination of water pressure and pulsations
to remove plaque and debris from between teeth and below the
gumline. The device operates on a voltage of 120 VAC, 60 Hz.
Product Usage Instructions:
- Unit Prep: Before using the water flosser, it
is recommended to visit waterpik.com/welcomeWF and register your
product to receive over $50 in savings at
waterpik.com/registration. Fill the reservoir with warm water and
firmly replace it on the base. - Water Floss:
- Turn the power switch ON.
- Insert the flossing tip until it clicks into place.
- Turn the pressure switch to high, point the tip into the sink,
and turn both the power and water switches ON until water flows.
Then, turn both switches OFF. - To start flossing, turn the power and water switches on. Begin
with low pressure and gradually increase to your preference. - While flossing, keep your lips closed enough to prevent
splashing, but still allow water to flow from your mouth into the
sink. - To avoid mess, always keep the flossing tip in your mouth while
the unit is on.
Note: The instructions provided above are in
English. For Spanish instructions, refer to the Spanish section of
the manual.
QUICK START GUIDE
WP-150 Series
1 Unit Prep
Visit waterpik.com/welcomeWF
Register your product and receive over $50 in savings. waterpik.com/registration
FILL
ON OFF
Fill reservoir with warm water and replace it firmly on the base.
2 Water Floss
POWER ON
LOW
O
I
1·2 ·3· 4 ·5· 6·7·8
INSERT
ON
Insert tip until it clicks into place.
O
I
1 ·2 ·3 ·4 ·5 ·6·7· 8
ON OFF
POWER ON
HIGH
O
I
1·2 ·3· 4 ·5· 6·7·8
· 9 ·10
Turn pressure to high, point tip into sink, turn power and water switches ON until water flows. Turn switches OFF.
· 9 · 10
· 9 ·10
Turn power and water on. Start on low pressure and increase to your liking.
Close lips enough to prevent splashing, while still allowing water to flow from mouth into the sink.
Aim water at a 90° angle to your gumline. Follow the gumline and pause briefly between teeth.
TO AVOID MESS: KEEP TIP IN MOUTH WHILE UNIT IS ON.
This device is compatible with voltages of 120 VAC, 60 Hz.
©2019 Water Pik, Inc.
GUÍA RÁPIDA PARA COMENZAR
WP-150 Serie
1 Preparación de la unidad
Visite waterpik.com/welcomeWF
Registre su producto y reciba más de USD 50 en descuentos.
waterpik.com/registration
LLENE
ON OFF
INSERTE
ON
ENCENDIDO
ALTO
O
I
1·2 ·3· 4 ·5· 6·7·8
· 9 ·10
Llene el depósito con agua tibia y vuelva a colocarlo firmemente en la base.
Inserte el cabezal con firmeza hasta que encaje en su lugar.
2 Cómo utilizar el Irrigador oral
ENCENDIDO
BAJO
O
I
1·2 ·3· 4 ·5· 6·7·8
O
I
1 ·2 ·3 ·4 ·5 ·6·7· 8
ON OFF
Coloque la presión en Alto, apunte el cabezal hacia el interior del lavabo, encienda los interruptores de encendido y de agua hasta que el agua fluya.
· 9 · 10
· 9 ·10
Encienda el suministro de energía y el agua. Comience con presión baja e increméntela según su agrado.
Cierre los labios lo suficiente para evitar salpicar mientras el agua continúa fluyendo de la boca hacia el lavabo.
EVITE DERRAMES: COLOQUE EL CABEZALEN LA BOCA ANTES DE ENCENDER LA UNIDAD
El dispositivo es compatible con voltajes de 120 VCA, 60 Hz.
Dirija el agua hacia la encía en un ángulo de 90°. Siga la línea de las encías y haga pausas breves entre los dientes.
FN 20021812-F AB
Waterpik® Registration Form - Oral Health Products
