CORIculum Ramp with Winch
Product Information:
The ramp with winch is a product designed for ages 5 and above.
It requires 0.5-1 hour of grit to assemble. The ramp is constructed
using Cori beams and can be customized to achieve the desired ramp
steepness. The product comes with a winch assembly that can be used
to pull objects up the ramp.
Product Usage Instructions:
- Start by unfolding a Cori beam or cutting a piece of cardboard
to the dimensions specified. - Add two 12-inch beams to the ramp, allowing them to overhang
about 2 inches. Use glue where indicated. - Cut and fold three 6-inch Cori beams to create the ramp support
structure. Ensure that the ramp from step 2 fits between the
vertical posts. Use glue where indicated. - Glue the ramp from step 2 to the support structure from step 3
to achieve the desired ramp steepness. The recommended ramp angle
is approximately 25 degrees. - Glue the snap-in brackets to the top of the vertical beams,
ensuring they are vertically aligned. - Assemble the winch and crank arm according to the provided
illustrations. Use glue if necessary. - Snap the winch assembly into the brackets from step 5, ensuring
it rotates freely. - Tie a loop to one end of the string and tie the other end to
the winch shaft. Turn the crank handle to pull an object up the
ramp.
If you have any questions or comments, you can contact CORI
support at [email protected]. Don’t forget to share your
designs using the hashtag #CoriCreate and follow CORI on Facebook,
Instagram, and Twitter. For more information, visit our website at
www.coricreate.com.
Ramp with winch
0.5-1 hour Grit required Ages 5+
1
Start the ramp with an unfolded Cori beam, or cut a piece of cardboard to the dimensions below.
Assembly Instructions
2
Add two 12 inch beams to the ramp from step 1 letting them overhang about 2 inches. Glue
where indicated.
Ramp shown upside down
3
Cut and fold three 6 inch Cori beams to the dimensions below to form the ramp support structure. Make sure the ramp from step 2
will fit in between the vertical posts. Glue where indicated.
4
Glue the ramp from step 2 to the support structure in step 3 to achieve desired ramp steepness. For this
example we chose a ramp angle of about 25 degrees.
5
Glue the snap in brackets to the top of the vertical beams making sure they are
vertically aligned.
6
Assemble the winch and the crank arm as illustrated. Use glue if needed.
7
Snap the winch assembly into the brackets from step 5. It should rotate freely.
8
Tie a loop to one end of the string, and tie the other end to the winch
shaft. Turn the crank handle to pull
an object up the ramp.
Ramp shown with optional wagon
CORI support is here to help. Contact us at [email protected] if you have any questions or comments. Share your designs using our hashtag #CoriCreate. Follow us on Facebook, Instagram and Twitter.
www.coricreate.com
CORI
