Anko Solar Powered 150 Led Multi Coloured Star Lights Instruction Manual

Solar Powered 150 LED Multi Coloured Star Lights

SOLAR POWERED 150 LED MULTI-COLOURED STAR LIGHTS

Product Information

The solar powered 150 LED multi-coloured star lights are
designed for outdoor use. The product consists of a solar cell, a
rechargeable battery, and LED lights. The solar cell charges the
battery during the day using sunlight, and the stored energy is
then used to power the lights at night. No additional power or
connections are required. The length of time the lights stay on
depends on the amount of sunlight received during the day.

Installation Instructions

  • This light set is designed for use OUTDOORS in an open
    (unshaded) location.
  • Do not position or place near barbecues, heaters, or any other
    direct sources of heat.
  • The solar panel should be located where sunlight can fall
    directly on it.

User Instructions

  • Remove all packaging before use and dispose of safely.
  • Ensure there are no pipes or mains cables immediately
    underneath, then fix the solar panel assembly to the ground using
    the anchor spike.
  • Turn the ON/OFF switch at the bottom of the panel to ON.
  • Place the product at the desired locations, ensuring that the
    cables are routed to avoid tripping hazards.
  • Press the ‘MODE’ switch on the solar panel to select the
    desired function: ‘Steady on’ or ‘Flashing’.

Battery Replacement

The battery is non-replaceable. DO NOT attempt
to replace it.

Bulb Changing

The light set is constructed with
non-replaceable bulbs. DO NOT attempt to replace any of the bulbs
in the light set.

Warnings

  • This product is designed for use OUTDOORS ONLY.
  • Remove all packaging before use.
  • This product is not a toy, keep out of reach of children.
  • This product has small parts, which may pose a choking hazard
    if detached.
  • The end point of the ground stake is sharp. Please do not allow
    children to play with the anchor spike.
  • Keep away from fire and sources of heat.
  • Some condensation may form inside the unit or solar panel in
    cold conditions. This is normal and can be ignored.
  • Direct sunlight is required to charge the battery.

Assembly diagram:

Assembly Diagram

Keycode: 42780199

SOLAR POWERED 150 LED MULTI-COLOURED STAR LIGHTS
These instructions are for your safety. Please read through them thoroughly before use and retain for future reference.
Introduction
The solar light consists of a solar cell, a rechargeable battery and LED lights. All these are preassembled. During the day time, light from the sun charges up the batteries. At night, the energy stored in the batteries is used to power the light. No other power or connections are required. The length of time the light stays on is dependent on how much sunlight has been received during the day.
Installation Instructions
1. This light set is designed for use OUTDOORS in an open (unshaded) location. 2. Do not position or place near barbecues, heaters or any other direct sources of heat. 3. The solar panel should be located where sunlight can fall directly on the panel.
Shadows from buildings, trees, walls/hedges and similar objects should be avoided if possible as these will reduce performance. 4. Try to avoid locations where light from other sources (e.g. streetlights, floodlights etc.,) may affect the PIR sensor. This product is designed only to illuminate in dark conditions, and may not operate if light reflects on the panel. 5. This product can be left outside in rain, but should not be exposed to water jets or immersed. For optimum lifespan, the solar panel should be stored indoors during extreme weather conditions (prolonged snow and frost).

User Instructions
1. Remove all packaging before use and dispose of safely. 2. Ensure there are no pipes or mains cables immediately underneath, then fix the solar
panel assembly to the ground by the anchor spike. 3. Turn the ON/OFF switch at the bottom to “ON”. 4. Place the product at the desired locations. Ensure the cables are routed so that they
do not present a tripping hazard. 5. Press `MODE’ switch on solar panel to select function: `Steady on’ or `Flashing’.
Battery Replacement
The battery is non-replaceable. DO NOT attempt to replace it.
Bulb Changing
The light set is constructed with non-replaceable bulbs. DO NOT attempt to replace any of the bulbs in the light set.
Warning This product is designed for use OUTDOORS ONLY . Remove all packaging before use. This product is not a toy, keep out of reach of children. This product has small parts, which may pose a choking hazard if detached. The end point of the ground stake is sharp. Please do not allow children to play with
the anchor spike.
Keep away from fire and sources of heat. Some condensation may form inside the unit or solar panel in cold conditions. This is
normal and can be ignored.

Direct sunlight is required to charge the battery.

Assembly diagram:
1

2

3

Keycode: 42780199

Documents / Resouces

Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.


Related Manuals