09-2550 Surveyor’s Floor Lamp

Product Information

The product is a Surveyors Floor Lamp, model number
09-2550/09-2552. It consists of several parts, including a tripod
base with unfolded legs (H), a pole (E) with a top nipple (F), a
harp (C) with a harp saddle (D), a finial (A), a lamp shade (B),
and an electrical plug (M).

The lamp requires assembly before use. It is important to
carefully remove all parts from the packaging and check them
thoroughly. Make sure to remove the white plastic bushing inside
the bottom opening of the pole (E) before assembly. Do not plug the
lamp into an electrical outlet until assembly is completed.

Assembly Instructions

1. Remove all parts carefully from the carton.
2. Unfold the tripod legs (H) on the floor.
3. Remove the white plastic bushing inside the bottom opening of
   the pole (E).
4. Screw the pole (E) onto the top nipple of the pole (F).
5. Tighten the cord clamp screw (Q).
6. Insert the harp (C) into the harp saddle (D) by squeezing both
   sides of the harp.
7. Remove the finial (A) from the harp (C). Place the lamp shade
   (B) over the bolt attached to the top of the harp. Screw the finial
   (A) onto the bolt to secure the shade to the harp.
8. Install a bulb of the correct type and wattage as indicated on
   the lamp’s label.
9. Remove the protective plastic (L) from the electrical plug
   (M).
10. Plug the lamp into an electrical outlet.

Adjustment Instructions

1. Loosen the adjustment key (G).
2. Adjust the lamp’s height by sliding the pole (F) to the desired
   position.
3. Tighten the adjustment key (G) to secure the lamp in
   place.

09-2550/09-2552 Surveyors Floor

(A) (B)
(C) (D) (E) (F) (G)
(H)

ASSEMBLY INSTRUCTIONS
Carefully remove all parts from packaging and check materials thoroughly before disposing of box and packaging.
CAUTION: Do not plug the lamp into electrical outlet before assembly is completed.
1. Remove all parts carefully from the carton.
2. Unfold the tripod legs (H) on the floor.
3. Remove white plastic bushing inside bottom opening of pole (E) before assembly.
4. Screw pole (E) on top nipple of pole (F).
5. Tighten cord clamp screw (Q).
6. Insert harp (C) into the harp saddle (D) by squeezing both sides of the harp.
7. Remove finial (A) from harp (C). Place lamp shade (B) over the bolt attached to the top of the harp. Screw finial (A) onto the bolt to secure the shade to the harp.
8. Install bulb of correct type and wattage. See label on lamp.
9. Remove protective plastic (L) from electrical plug (M).
10.Plug lamp into electrical outlet.

(Q)

ADJUSTMENT INSTRUCTIONS

1. Loosen adjustment key (G).

(L)

2. Adjust lamp by sliding pole (F) to desired height.

(M)

3. Tighten adjustment key (G).

©2008 Ethan Allen Global, Inc.