Psi Woodworking Products Pkhkkxx Bolt Action Hobby Knife Instruction Manual

PSI Woodworking PRODUCTS PKHKKXX Bolt Action Hobby Knife

Product Information

• Product Name: Bolt Action Hobby Knife
• Manufacturer: PSI Woodworking Products

Product Usage Instructions

1. 1. Preparing the Blank:
      • Trim the material down flush to the ends of the tubes.
      • Do not trim past the end of the tube to avoid interference with assembly and operation of the mechanism.
      • Use a barrel trimmer to clean the inside of the tube.

1. 1. Turning the Blank:
      • Attach the headstock end bushing and mandrel saver tailstock.
      • Turn the blank to a profile of your choice.

1. 1. Knurled Nut Setup:
      • Add spacer bushings past the threads.
      • Insert the live center into the mandrel shaft.
      • Align the center point into the mandrel dimple.
      • Secure the blank and bushings by sliding and locking the tailstock directly against the bushings and tightening the quill using the knurled nut.
      • Avoid over-tightening to prevent damage to the mandrel shaft.

1. 1. Sanding and Polishing:
      • Sand the blank using different sandpaper grits.
      • Apply polish and follow the instructions provided by the polish
        manufacturer for curing.

1. Assembly:
   • Refer to Diagram D for the parts layout.
   • Ensure the indexing tab on the back of the knife goes into the slot in the shaft for alignment.
   • The index slot should line up with the clip when the knob is fully back.
   • Assemble the back end assembly, bolt shaft, side channel, thumb knob, and blade according to the provided diagram.