Mareko Deep Platen Assembly Instruction Manual

Deep Platen Assembly

Product Information: MAREKO Deep Platen Assembly

The MAREKO Deep Platen Assembly is a component designed for use
with a machine. It consists of a Wear Plate and short 1/4 Hex
Bolts.

Wear Plate

The Wear Plate is a durable plate that is used to protect the
Flat Platen of the machine. It is installed using the short 1/4 Hex
Bolts.

Short 1/4 Hex Bolts

The short 1/4 Hex Bolts are used to secure the Wear Plate to the
Flat Platen of the machine. It is important to align the Wear Plate
with the belt on the machine before tightening the bolts.

Please note that overtightening the bolts may strip the threads
in the wear plate, so it is important to tighten them securely but
not excessively.

Product Usage Instructions: MAREKO Deep Platen Assembly

1. Locate the Wear Plate and the short 1/4 Hex Bolts.
2. Position the Wear Plate on the Flat Platen of the machine,
   aligning it with the belt.
3. Insert the short 1/4 Hex Bolts through the designated holes on
   the Wear Plate and into the Flat Platen.
4. Tighten the bolts securely using an appropriate tool, ensuring
   that the Wear Plate is firmly attached to the Flat Platen.
5. Be careful not to over-tighten the bolts, as this can strip the
   threads in the wear plate. Tighten them securely but not
   excessively.

Following these instructions will properly install the MAREKO
Deep Platen Assembly onto your machine, providing protection to the
Flat Platen during usage.

MAREKO DEEP PLATEN ASSEMBLY
Place one Teflon washer between Arm and D-Plate where the D-Plate will rotate (red arrow). Install the Platen D-Plate with ½-13 X 2-1/2 Carriage Bolt, Flat Washer, and Nylock Nut on the Short Arm. Insert the ½”-13 X 2-1/2″ Carriage Bolt into the slot and secure with ½-13 Internal Threaded Adjustable Handle.
Install the 2″ Idler Wheel into the top (thinner section) of the Platen D-Plate using ½”-13 X 3″ Hex Bolt, Spacer, and Nylock Nut. Install the 4″ Contact Wheel into the bottom (wider section) of the Platen D-Plate using ½”-13 X 3″ Hex Bolt, Spacer, and Nylock Nut. BE CAREFUL NOT TO OVERTIGHTEN BEARINGS. THE WHEEL SHOULD SPIN FREELY BUT THERE SHALL NOT BE EXTRA SPACE BETWEEN THE BEARINGS AND NUT OR BOLT HEAD. Install the Platen onto the Platen D-Plate using ¼”-20 Threaded knobs and ¼”-20 X 1″ Carriage Bolts.

Install the Wear Plate to the Flat Platen using short 1/4″ Hex Bolts. Align with belt on machine and tighten in place. Overtightening may strip the threads in the wear plate.