Led S Work 12000 Lm 360 Degree Led Work Light Instruction Manual

Led S Work 12000 Lm 360 Degree Led Work Light Instruction Manual

LED shada logoLED s work 12000 lm 360 Degree LED Work Light LED s work 12000 lm 360 Degree LED Work Light productOVERVIEW

LED s work 12000 lm 360 Degree LED Work Light fig 1

Safety warning

Ensure you have fully read and understood the instructions in this document before you install or use the product following the installation/wire diagram [when applicable). Keep this document for future reference and only use the product as described in this document. Any other use of the product than described in this manual may damage the product or cause injury to the user [e.g. due to a short circuit, fire or electric shock). Disconnect the product from the power source if problems occur. Do not drop the product and avoid bumping. Do not use the product if a part is damaged or defective. Replace a damaged defective product immediately. When a non-standard consumer [power)installation is required this should be performed by a qualified technician to reduce the risk of an electric shock. make sure the product is sufficiently ventilated during use. never cover an electrical [LED) device during usage since it can generate heat causing damage. Besides LED can be extremely bright and may cause serious eye damage so don’t stare at it directly. When a product is meant for indoor and/or outdoor use only, this will be mentioned on the product/parts or in the manual. Keep the product out of reach of children or animals.

Cleaning and maintenance warning

Do not use cleaning solvents or abrasives. Do not clean the inside of the device. Do not attempt to repair the device when the device does not operate correctly, replace it. Clean the outside of the device using a soft, damp cloth [don’t use microfiber cloth).

Support

If you need further help or have comments or suggestions please visit www.shada.nVnVcontact

Class
the metal parts in these devices are connected to electrical earth. The current will flow in the earth conductor in case of failure.LED s work 12000 lm 360 Degree LED Work Light fig 2Caution

  • Risk of electric shock
  • A cover with damage must be replaced LED s work 12000 lm 360 Degree LED Work Light fig 3
  • IK08: Protected against 5 joules of impact
  • Non-replaceable control gearLED s work 12000 lm 360 Degree LED Work Light fig 4
  • IP54-Housing: Products with IP54are protected against dust ingress and splash waterproof.LED s work 12000 lm 360 Degree LED Work Light fig 5
  • Useful Lumens: Testing Methods: measured in sphere:360°
  • Do not stare at the light sourceLED s work 12000 lm 360 Degree LED Work Light fig 6
  • Non-replaceable light source
  • The item should be disposed of separately from household waste. The item should be handed in for recycling on accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment.
  • This product carries the CE mark which confirms that this product meets EU safety, health and environmental protection requirements

D.O.C. https://www.shada.nVp/300842

Molenmakershoek 28, nL-7328 JK APELDOORN -The Netherlands
www.shada.nl

Documents / Resouces

Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.


Related Manuals