CC-1200D Balanced Phono Cable
Product Information
The product is a MC cartridge (Moving Coil cartridge) designed
for audio playback. It features a balanced transmission of the
cartridge output, PC TripleC Material, and a rhodium-plated DIN
Connector known for high sound quality. The product is manufactured
by Kyodo Denshi Engineering Co., Ltd., a renowned audio brand.
Product Usage Instructions
- Connect the 5-pin DIN Connector to the tone arm carefully,
considering any tight connector dimensions. - Connect the earth terminal to both the pre-amplifier and
phono-amplifier. However, there may be cases where less noise is
experienced if the earth is not connected. It is advisable to check
before use. - Ensure that RCA and XLR connectors are not connected
simultaneously to avoid operational issues and potential
defects. - Refer to the provided diagram for proper connection of the
inputs and outputs.
For further assistance or inquiries, please contact Kyodo Denshi
Engineering Co., Ltd. at:
Address: 8-40-17 Shinyoshidahigashi, Kohoku-ku, Yokohama-shi,
Kanagawa 223-0058 Japan
Phone: +81-45-710-0975
Email: [email protected]
Website: https://www.phasemation.com
$$%
#”-“/$&%1)0/0$”#-&
Owner’s Manual
/BNFT
‘VODUJPOT
BOE$POOFDUJPOT
.BJO’FBUVSFT 1. A Balanced Transmission of the Cartridge Output
The power generation of the MC cartridge is by the coil. Since opposite phase (push-pull) signals are generated at both ends of the coil, it makes a balanced operation. Therefore, balanced transmission to the phono amplifier is the utmost way to minimize loss. The weak voltage of the cartridge is what makes it exert its strength.
2. PC TripleC Material
In order to bring out 100% of the cartridge’s performance, an ultra-thick PC Triple C wire of 1.25 Sq (mm²) was adopted. PC Triple C’s low distortion rate and high conductivity allow the weak signal from the cartridge to be transmitted to the phono amplifier without loss of signals.
3. Rhodium Plating
The DIN Connector is rhodium-plated which has a reputation for high sound quality.
8IFODPOOFDUJOHUP5
5PIN DIN Connector Connect it to the tone arm. There are cases when the connector dimensions at the tone arm is tight and therefore connect it carefully.
8IFODPOOFDUJOHUP&”
Kyodo Denshi Engineering Co., Ltd. 8-40-17 Shinyoshidahigashi, Kohoku-ku, Yokohama-shi, Kanagawa 223-0058 Japan TEL: +81-45-710-0975 FAX: +81-45-710-0976 E-mail: [email protected] URL: https://www.phasemation.com
is the original audio brand of Kyodo Denshi Engineering Co., Ltd.
9-3$POOFDUPS 3JHIU
5IFPOFXJUIUIFSFE SJOHJT3DI
Normal operation cannot be performed if RCA and XLR are connected at the same time and can cause a defection.
PUSH
2
1
3
NEUTRIK
5
9-3$POOFDUPS -FGU
5IFPOFXJUIUIFXIJUF SJOHJT-DI
PUSH
2
1
3
NEUTRIK
MODEL EA-1200EQ
DC IN
&BSUI5FSNJOBM Connect the earth also to the pre-amplifier and phono-amplifier. However there are rare cases that there is less noise if not connected to earth. Therefore check before using.
9-3$POOFDUPS 3JHIU
5IFPOFXJUIUIFSFE SJOHJT3DI
9-3$POOFDUPS -FGU
5IFPOFXJUIUIFXIJUF SJOHJT-DI
Normal operation cannot be performed if RCA and XLR are connected at the same time and can cause a defection.
OUTPUT 1
2
INPUT GND
GND
3
PUSH
2
1
3
NEUTRIK
2
PUSH
2
1
3
NEUTRIK
1
PUSH
2
1
3
NEUTRIK
INPUT
1
PUSH
2
1
3
NEUTRIK
2
PUSH
2
1
3
NEUTRIK
3
PUSH
2
1
3
NEUTRIK
GND GND
Earth Terminal For EA-1200, connect the earth to the terminal of either unit. However there are rare cases that there is less noise if not connected to earth. Therefore check before using.
EA-1200
OUTPUT 1
MODEL EA-1200EQ
DC IN
2
Phasemation
