Black Decker Bd1007 Ratchet Straps Instruction Manual (+ PDF)

BD1007 Ratchet Straps
Instruction Manual

Contents hide

BD1007 Ratchet Straps

WARNING: READ AND UNDERSTAND ALL INSTRUCTIONS AND FULLY COMPLY WITH ALL WARNINGS.
FAILURE TO DO SO MAY RESULT IN DAMAGE TO THIS PRODUCT, PERSONAL PROPERTY AND/OR PERSONAL INJURY.

With ratchet closed, thread webbing from the center spool through the ratchet reel.
Pull webbing through, removing the slack.
Release the ratchet by lifting the release bar. To tighten, raise and lower ratchet handle; do not overtighten. (Make sure to have a minimum of 2 full wraps of webbing around the reel.)
Keep ratchet in closed position to lock.

TO RELEASE:

To unlock, pull the release bar until the ratchet is completely ﬂat and open
Grab webbing and pull to release.

WARNING:

ANSI approved eye protection to be worn at all times during use.
DO NOT use strap that has fraying, wear, broken or worn stitching, tears, cuts or defective hardware. If the strap is damaged DO NOT use it and discard it.
DO NOT exceed the working load limit of the strap; taking into account the strap, the load, the vehicle anchor points, strap conﬁguration and angle, etc.
DO NOT over-tighten straps.
NEVER stand in direct path of a tension loaded strap.
Maintain and store straps properly. Straps should be protected from mechanical, chemical and environmental damage.
ALWAYS protect straps in contact with edges, corners, protrusions, or abrasive surfaces with materials of suficient strength, thickness and construction to prevent damage.
Manufacturer is not liable for accidents caused by material deterioration or improper use.
For more information on the manufacturer’s warranty, visit www.blackanddeckerstraps.com, or contact BCS at (877) 257-8727 or email [email protected]

The warranty of this product is covered by BCS International.
WARNING: CANCER AND REPRODUCTIVE HARM
– www.P65Warnings.ca.gov

©2022 Black & Decker, Inc.
Black & Decker and the Black & Decker Logo are trademarks of Stanley Black & Decker, Inc. or one of its affiliates, and are used under license.
Products are distributed by: BCS International
Made in China

WORK STRENGTH
833 LB. / 377.8 KG.
BREAK STRENGTH
2500 LB. / 1134 KG.
www.BLACKANDDECKER.com
www.BLACKANDDECKERSTRAPS.com