Toshiba Te3-kp-kit Voltage Solid State Starter Instructions

TE3-KP-Kit Voltage Solid State Starter

Product Information:

The product is a keypad assembly that is designed to be mounted
on a door or panel with a specific cutout size of 3.6 x 4.4 inches
(91mm x 112mm). It comes with a pressure-sensitive adhesive gasket
for easy installation.

Product Usage Instructions:

1. Begin by removing the keypad assembly from its existing mount
   location.
2. Disconnect the existing short cable from the keypad assembly
   and discard it.
3. Peel off the backing on one side only of the provided
   pressure-sensitive adhesive gasket.
4. Attach the gasket to the back of the keypad.
5. Peel off the backing from the gasket attached to the
   keypad.
6. Place the keypad on the outside of the door or panel with the
   3.6 x 4.4-inch (91mm x 112mm) cutout.
7. Attach the longer cable provided in place of the removed short
   one.

ILLUSTRATION 1.

ILLUSTRATION 2.

1. REMOVE KEYPAD ASSEMBLY FROM EXISTING MOUNT LOCATION. 2. DISCONNECT EXISTING SHORT CABLE FROM KEYPAD ASSEMBLY
AND DISCARD.

1. PEEL OFF BACKING ON ONE SIDE ONLY OF THE PROVIDED PRESSURE SENSITIVE ADHESIVE GASKET.
2. ATTACH THE GASKET TO THE BACK OF THE KEYPAD.

ILLUSTRATION 3.
4.40″ 112mm CUTOUT
3.60″ 91mm CUTOUT
DOOR OR PANEL WITH CUTOUT
1. PEEL OFF BACKING FROM THE GASKET ATTACHED TO THE KEYPAD. 2. PLACE KEYPAD ON THE OUTSIDE OF DOOR OR PANEL WITH 3.6″ X 4.4″ CUTOUT. 3. ATTACH LONGER CABLE PROVIDED IN PLACE OF THE REMOVED SHORT ONE.