MD69 Venosa Maxi Wall Washer
Venosa Maxi Wall Washer
The Venosa Maxi Wall Washer is a downlight product with the
product code MD69. It requires a power input of 220-240V AC/50Hz to
the driver and is recommended to have a minimum space of 75mm
around the fitting for air ventilation to extend the product
lifetime. It is important to not interchange any parts of this
fitting and to allow a minimum distance between the fitting and
illuminated subject of 800mm. Do not touch the fitting when in use,
do not install fitting near any heat source, and do not install any
inductive loads such as exhaust fans etc. within the same lighting
circuit of the current fitting as issues caused by such connections
will not be covered under our warranty policy.
Installation Steps
- Ensure that the mains power is turned off.
- Cut required holes in the ceiling. Ensure minimum space
requirements between fitting and driver. See Picture 1. - Pass the driver power supply wires through the cutout and plug
into mains socket. - Connect the driver to the light fitting using the quick
connector. See Picture 2. - Mount fitting into ceiling and secure using the spring
clips. - Switch on the mains. Installation is complete. See Picture
3.
If you have any questions about the installation of this
product, please contact Mondolux.
Venosa Maxi Wall Washer
DOWNLIGHT
Product code MD69
mondolux.com.au
Installation Manual
Notes
This fitting requires 220-240V AC/50Hz power input to the driver. Do not interchange any parts of this fitting. Its recommended to have minimum space (75mm) around the fitting for air
ventilation to extend the product lifetime. Allow a minimum distance between fitting and illuminated subject of 800mm. Do not touch fitting when in use. Do not install fitting near any heat source. Do not install any inductive loads such as exhaust fans etc. within the same
lighting circuit of the current fitting. Issues caused by such connections will not be covered under our warranty policy. If you have any questions about the installation of this product, please contact Mondolux.
Installation Steps
1. Ensure the mains power is turned off. 2. Cut required holes in ceiling. Ensure minimum space requirements between fitting
and driver. See Picture 1. 3. Pass the driver power supply wires through the cutout and plug into mains socket. 4. Connect the driver to the light fitting using the quick connector. See Picture 2. 5. Mount fitting into ceiling and secure using the spring clips. 6. Switch on the mains. Installation is complete. See Picture 3.
ON
OFF
OFF
95mm
ON
ON
OFF
