WP1013S Electronic Controller Switch
Product Information:
This device complies with Part 15 of the FCC rules. It is
designed to operate without causing harmful interference and is
capable of accepting interference from other devices. Any changes
or modifications not approved by the responsible party for
compliance may void the user’s authority to operate the
equipment.
The recommended distance between the user and the product should
be no less than 20cm.
Product Usage Instructions:
- Reorient the receiving antenna to optimize signal
reception. - Increase the separation between the equipment and the receiver
to minimize interference. - Connect the equipment into an outlet on a circuit different
from the one to which the receiver is connected. This helps in
reducing potential interference. - If you require further assistance, consult the dealer or an
experienced radio/TV technician.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try correct the interference by one or more of the following measures:
Reorient the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into and outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
The distance between user and products should be no less than 20cm
