Product Information

The product is a device that has undergone radiated emission and
RF conducted tests. The tests were performed to ensure that the
product meets regulatory standards for electromagnetic
emissions.

Radiated Emission Test Setup Below 1GHz

This test setup is used to measure the radiated emissions of the
product below the frequency of 1GHz. It helps determine the
electromagnetic interference levels emitted by the product within
this frequency range.

Radiated Emission Test Setup Above 1GHz

This test setup is used to measure the radiated emissions of the
product above the frequency of 1GHz. It helps determine the
electromagnetic interference levels emitted by the product within
this frequency range.

RF Conducted Test Setup

This test setup is used to measure the conducted emissions of
the product. It helps determine the electromagnetic interference
levels emitted by the product through its RF conductive
pathways.

Product Usage Instructions

To use the product correctly and ensure compliance with
regulatory standards, please follow these instructions:

Ensure that the product is placed in an appropriate test
environment with minimal external electromagnetic
interference.
Connect the necessary equipment as per the radiated emission or
RF conducted test setup instructions provided in this manual.
Power on the product and allow it to stabilize for a few
minutes before conducting any tests.
Perform the radiated emission or RF conducted tests as required
for your specific application.
Record the test results accurately and compare them against the
regulatory standards to ensure compliance.
If the product does not meet the required standards, consult
the troubleshooting section of this manual or contact customer
support for assistance.

Following these instructions will help you properly use the
product and ensure that it meets regulatory standards for
electromagnetic emissions.

View Fullscreen

Report No.: AGC00213220603AP01 Page 1 of 2
TEST SETUP PHOTOS
RADIATED EMISSION TEST SETUP BELOW 1GHz
RADIATED EMISSION TEST SETUP ABOVE 1GHz

Report No.: AGC00213220603AP01 Page 2 of 2
RF CONDUCTED TEST SETUP
****************************************End of Report*************************************