ET-0454 Wall Climber RC Venom Car
Product Overview
The ET-0454 1:24 Wall Climber RC Venom Car is a
remote-controlled car that can move on floors and walls. It comes
with a remote controller and an instruction manual. The car is
suitable for ages 8 and above.
Package Contents
- 1 Wall Climber Remote Control Venom Car (15.9cm x 7cm x
4.5cm) - 1 Remote Controller (21cm x 5.7cm x 3.7cm)
- 1 Instruction Manual
Specifications
- Wall Climber Remote Control Venom Car Power supply: Built-in
Li-ion Battery 3.7V / 500 mAh - Remote Controller Power supply: 2 x AAA 1.5V Batteries
(alkaline type preferred, not included) - Frequency: 27 MHz
Product Usage Instructions
Power On/Off
To turn on the Wall Climber RC Venom Car, slide the
FLOORS/OFF/WALLS switch to FLOORS for normal running or WALLS for
wall climbing. To turn off the car, slide the switch to OFF.
Standard Control
Use the remote controller to control the car’s movement. The
forward button moves the car forward, and the backward button moves
it backward-right. Always pay attention when controlling the Remote
Control Car to avoid losing control.
Batteries Installation For Remote Controller
To install batteries into the Remote Controller, unscrew the
screw on the battery box cover to open the cover. Insert 2(Two) X
AAA 1.5V Alkaline Batteries (Not Included) into the battery box.
Batteries should be placed as shown on the diagram. Replace the
battery box cover and tighten the screw. When inserting the
batteries, you must insert according to the correct polarity, or
the Remote Control won’t function if batteries are reversed.
Charging the Remote Control Venom Car
Always use an appropriate 5V input charger/Adapter to charge the
product. DO NOT USE a Quick Charging USB Adapter to charge the
product as it might damage the product. Use the Micro USB charging
cable (not included) and connect the Micro USB plug to the Micro
USB charging port on the car.
Performance Tips
Do not drive the Wall Climber RC Venom Car on grass, sand, or
water. Do not drive it in windy or rainy weather, and do not drive
it into any sharp object. Keep fingers, hair, and loose clothing
away from the car. Always use a dry and soft cloth to clean this
product, avoid exposing it to sunlight or heat, and avoid immersing
it in water.
ET-0454 1:24 Wall Climber RC Venom Car Instruction Manual Size : 420 x 110 mm
20 APR 2023
AGES Product Overview
8+
WALL CLIMBER RC VENOM CAR
Instruction Manual
Thank you for purchasing the Wall Climber RC Venom Car. This manual provides more information about this RC Car,
please read the instructions before using.
Wall Climber Remote Control Venom Car
Package Contents
Includes: 1(One) Wall Climber Remote Control Venom Car 6.26in. x 2.76in. x 1.77in. (15.9cm x 7cm x 4.5cm). 1(One) Remote Controller 8.27in. x 2.24in. x 1.45in. (21cm x 5.7cm x 3.7cm). 1(One) Instruction Manual
Standard Control
Power On/Off
Note: To avoid losing control, always pay attention when controlling the Remote Control Car.
Power On / Off
Specifications
Wall Climber Remote Control Venom Car Power supply: Built in Li-ion Battery 3.7V / 500 mAh Remote Controller: Power supply: 2 x “AAA” 1.5V Batteries (alkaline type preferred, not included) Frequency: 27 MHz
Forward Button
Control Wall Climber Remote Control Venom Car to move forward
DC5V FLOORS OFF WALLS
Remote Controller
Remote Controller
Instruction Manual
Instruction Manual
Forward Button
Backward-right Button
Backward Button
Control Wall Climber Remote Control Venom Car to move backward-right
Power On/Off
Slide the FLOORS/OFF/WALLS Switch to “FLOORS” to turn on the Wall Climber RC Venom Car for normal running.
Slide the FLOORS/OFF/WALLS Switch to “WALLS” to turn on the Wall Climber RC Venom Car for wall climbing.
Slide the FLOORS/OFF/WALLS Switch to “OFF” to turn off the Wall Climber RC Venom Car.
Charging the Remote Control Venom Car
Micro USB Charging Port
DC5V FLOORS OFF WALLS
For your safety, please always use appropriate 5V input charger/Adapter to charge the product. DO NOT USE Quick Charging USB Adapter to charge the product, as it might damage the product. 1. Use the Micro USB charging cable. (Not Included) 2. Connect the Micro USB plug to Micro USB charging port on the
Wall Climber RC Venom Car, then connect the USB plug to a USB port on a computer or wall adapter to begin charging. 3. The LED Indicator will turn red while charging and will turn off once fully charged. NOTE: · You must select a qualified charger from a regular manufacturer. · You must charge the Wall Climber RC Venom Car if it has been not used for more than 6 months.
Batteries Installation For Remote Controller
We Can Play the Car On
+
–
FLDOROOINRVSES
–
+
+
+
–
–
–
–
+
+
To install batteries into the Remote Controller, unscrew the screw on the battery box cover to open the cover. Insert 2(Two) X AAA 1.5V Alkaline Batteries (Not Included) into the battery box. Batteries should be placed as shown on the diagram. Replace the battery box cover and tighten the screw.
Notice:
When inserting the batteries, you must insert according to the correct polarity, the Remote Control won’t function if batteries are reversed.
OCNLIWMABLSLS
Performance Tips
IMPORTANT: BATTERY INFORMATION
Warning
FCC Statement
1. Do not drive the Wall Climber Rc Venom Car on grass, sand or go through water.
2. Do not drive the Wall Climber Rc Venom Car in windy or rainy weather. 3. Do not drive the Wall Climber Rc Venom Car into any sharp object. 4. Keep fingers, hair and loose clothing away from Wall Climber Rc Venom Car.
Care and Maintenance
Always use dry and soft cloth to clean this product.
Avoid this product from being exposed to sunlight or heat.
Avoid immersing these toys in water, otherwise, the electronic parts may be damaged.
Check the product regularly. If any damages are discovered, please stop using immediately, until it is completely repaired in good working condition.
IMPORTANT: BATTERY INFORMATION
CAUTION: 1. TO AVOID BATTERY LEAKAGE a. Always follow the instructions carefully. Use only batteries specified and be sure to insert them correctly by matching the + and – polarity markings. b. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries. c. Remove exhausted or dead batteries from the product. d. Remove batteries if product is not to be played with for a long time. e. Do not short-circuit the supply terminals. 2. Should this product cause, or be affected by local electrical interference, move it away from other electrical equipment.Reset ( switching ON&OFF again or removing and re-inserting batteries) if necessary.
CAUTION:
1. TO AVOID BATTERY LEAKAGE a. Always follow the instructions carefully. Use only batteries specified and be sure
to insert them correctly by matching the + and – polarity markings. b. Do not mix old batteries and new batteries or standard (carbon-zinc) with
alkaline batteries. c. Remove exhausted or dead batteries from the product. d. Remove batteries if product is not to be played with for a long time. e. Do not short-circuit the supply terminals. f. RECHARGEABLE BATTERIES: Do not mix these with any other types of batteries.
Always remove from the product before recharging. Recharge batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
2. Should this product cause, or be affected by local electrical interference, move it away from other electrical equipment. Reset (switching ON & OFF again or removing and re-inserting batteries) if necessary.
For AAA Batteries
WARNING: TO AVOID BATTERY LEAKAGE
1) The batteries used with this product are small parts and should be kept away from small children who still put things in their mouths. If they are swallowed, promptly see a doctor and have the doctor phone American Association of Poison Control Centers (1-800-222-1222).
2) Always purchase the correct size and grade of battery most suitable for intended use.
3) Do not mix old and new batteries, alkaline, standard (Carbon – Zinc) or rechargeable (Nickel-cadmium) batteries.
4) Clean the battery contacts and those of the device prior to battery installation. 5) Ensure the batteries are installed correctly with the regard to polarity (+ and -). 6) Always remove batteries if consumed or if product is to be left unused for a
long time.
Li-ion battery charging warning statement:
The input to the USB Charging Adapter is 5V 1A. In order to charge the product in safe manner and reliable conditions, please only adopt certified appropriate charger/ adapter for charging the product. Only charge the product at ambient temperatures between 10 deg °C/ 50 deg °F and 40 deg °C/104 deg °F. Do not heat above 70 deg °C/158 deg °F, eg. Do not expose to sunlight or throw into fire. Please note that we won’t take any responsibility for any wrong operation (eg. Voltage higher than 5V) as this may result in severe injury or loss of property, and we cannot control the operating process during the time the user using this product.
This product is suitable to be used by people who has operating experience in remote toy or aged no less than 8 years old.
Please do not put the product in your mouth to prevent choking hazard of small parts.
Please do not put the finger into available interspaces.
This device complies with the part 15 of the FCC rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Please do not play the product in a brutal way such as throwing, crashing or twisting it.
Please store the smaller-sized product accessories in places that are out of reach of children, in order to avoid the occurrence of accidents.
Avoid placing the batteries in places in high temperatures and avoid exposure to heat.
When young children are operating the product, it shall be ensured that the adults are guiding and making sure the product control is within the viewing range of the controller (or instructor) so that it makes the control of the toy more convenient.
When the product is not in use, please switch off the power supplies of the toy, and remove the batteries from the product.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with instructions may cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. The user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or experienced radio/ TV technician for help.
Please note that we won’t take any responsibility for any wrong operation as this may result in severe injury or loss of property, and we cannot control the operating process during the time when the user assembles or uses this product.
RF warning statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Once this product is sold, we won’t be responsible for any safety responsibility during FCC ID: 2ADM5-ET-0454 the time the user operates or uses controls this products.
Distributed by 1616 Holdings, Inc. 701 Market Street, Suite 200 Philadelphia, PA 19106
Keep All Relevant Information for Future Reference
Item# ET-0454
