GS1028PS2 24-Port Gigabit PoE+ Switch
Installation Guide
Hardware Connection
Specifications
| Model | GS1028PS2 |
| Network Protocol | IEEE802.3 / IEEE802.3u / /IEEE802.3x |
| IEEE802.3ab / IEEE802.3z / IEEE802.3af/at | |
| PoE Standard | IEEE802.3af (15.4w) and IEEE802.3at (30W) |
| POE port output | DC48-55V |
| Power Pin | Power over spare pairs 1/2(+) , 3/6 (-) |
| Network Media | 10BASE-T: Cat3、4、5 or higher UTP(≤100 meter) |
| 100BASE-TX: Cat5 or UTP (≤100 meter) | |
| 1000BASE-TX: Cat5 or UTP (≤100 meter) | |
| Bandwidth | 8K |
| MAC | 4M |
| Packet Buffer Memory | 52Gbps |
| Packet Forwarding Rate | 38.7Mpps |
| Optical | Power input: AC100-240V 50/60Hz |
| Output: 52V5.76A | |
| Power Budget: 300W | |
| Power Supply | Single-Mode Fiber: 850nm, 1310nm |
| Transmission Distance: 550m/2Km | |
| Single-Mode Fiber: 1310nm, 1550nm | |
| Transmission Distance: 20/40/60/80/100/120km | |
| MTBF | 100,000 hours |
| Product Dimension | 410x185x44.5mm |
DIP Explanation
| VLAN | Port Isolation | Downlink designated ports are isolated from each other, only transmit data with the uplink port. |
| Default | Standard Switch | All ports communicate freely |
| Extend | Link Extension | The specified port speed drops to 10Mbps, max PoE transmission distance is 250 meters. |
LED and Interface Explanation
| PWR | Power supply indicator Red | ON | Powered |
| OFF | No power | ||
| 1-26 Port | RJ-45 LINK indicator Green | ON | 1000M Connect |
| OFF | 100M or Disconnect | ||
| 1-26 Port | RJ-45 ACT indicator Green | ON | Connecting |
| OFF | Disconnect | ||
| Flashing | Data Transmit |
EU declaration of conformity
Cudy hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/30/EU, 2014/35/EU, 2009/125/EC and 2011/65/EU.The original EU declaration of conformity may be found at http://www.cudy.com/
Email: [email protected]
Email: [email protected]
Website: www.cudy.com
Cudy Official Website
