Delmhorst BDX-30 Pin Type Moisture Meter Instructions
Meter
Each meter includes two short pieces of nylon cord to tie into tethers for the pin and connector caps, if desired.
Step 1 – Remove the connector cap.
Step 2 – Thread one end of the Tether through the cavity of the meter.
Step 3 – Feed both ends through the top side of the connector cap.
Step 4 – Tie a single knot on the end of the Tether.
Step 5 – Slide the connector cap to the end so that the knot is inside and place
the cap back onto the meter as shown.
Step 6 – Remove the Pin Cover Cap and repeat the same steps.
