RL 3634 Large Table Lamp
Product Information:
Product Name: Halifax Large Table Lamp
Item Number: RL 3634
Package Contents: Lamp base, harp, saddle, finial, shade, bulb
(not included), protective cover
Usage: Indoor use only
Product Usage Instructions:
- Carefully remove all parts from the box and place them on a
clean, soft surface. - Install the harp (B) onto the saddle (A) and adjust the harp to
the desired height. Then tighten the adjustment knobs (F). - Remove the finial (D) from the harp (B).
- Remove the shade (C) from its packaging and install it onto the
harp (B) using the finial (D). If the shade has additional
packaging, carefully cut it off from the interior to avoid
damages. - Install a light bulb into the socket.
- Remove the protective cover (E) from the plug.
- Plug the lamp into an electrical outlet.
- Test the fixture to ensure it is functioning properly.
Note: Before installation, make sure to inspect
the lamp and its contents carefully. If any damage or defects are
found, do not proceed with the installation. Retain all packaging
material until installation is complete and approved.
Care Instructions:
Clean the lamp only with a soft dry cloth or feather duster. Do
not use abrasive or chemical agents.
Important: This light fixture should be
installed in accordance with all applicable, local installation
codes, and by a person familiar with its construction and
operation, as well as the hazards involved.
ASSEMBLY INSTRUCTIONS
D
C (Packaged separately)
B Bulb not included F A
Halifax Large Table Lamp Item # RL 3634
NOTICE: This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED): Scissors
1. Carefully remove all parts from the box. Place on a clean, soft surface. 2. Install harp (B) onto saddle (A), adjust harp (B) to desired height, then
tighten adjustment knobs (F). 3. Remove finial (D) from harp (B). 4. Remove shade (C) from packaging and install to harp (B) using
finial (D). NOTE: If shade has additional packaging, carefully cut off from interior of shade to avoid damages. 5. Install light bulb into the socket. 6. Remove protective cover (E) from the plug. 7. Plug into electrical outlet and test the fixture.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
E
M
LI ST ED
US
