Zazu Baby Sleep Shusher With Light, Sound And Voice Recording Owner's Manual (+ PDF)

Home » Blog » Zazu Baby Sleep Shusher With Light, Sound And Voice Recording Owner's Manual

Contents hide

Take the light module from the belly. Place 3x AAA batteries (not included). Only use alkaline batteries, no Zinc Carbon.

Select the play MODE with button A
- OFF
- Light only
- Light and music
Set the cry sensor ON/OFF with button C
- The cry sensor will automatically activate the last played settings when your baby starts crying.
- Cry sensor will be active for 12 hours. Switch the product ON/OFF by pressing the big button D
- The sound and music will automatically switch OFF after 20 minutes.
Change volume with button B
- 3 Settings: loud / medium / soft
Change song with button D
- Double press the big button D and the music will change: heartbeat, white noise, shusher, lounge, lullaby 1,2,3, recorded song.
Record your own message with button D
- Keep pressing the big button D.
- When you hear the beep, the recording starts.
- You can record up to 30 seconds
- When finished, let go of the big button.

The beep will confirm that recording has finished.

WARNING! SAFETY GUIDELINES

Important! keep for future reference.
This ZAZU product is fully compliant with the EU, CA, AU, NZ, RU, CN & USA legislation.
Please keep the packaging away from small children.
Please ensure that the product is kept out of reach of small children and never allow your child to play with the batteries.
This product works with 3x AAA 1.5 V batteries (not included).
Only use the specified batteries.
Remove empty batteries from the product.
Batteries should only be placed by adults.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-Zn), or rechargeable (Ni MH) batteries.
Only use alkaline batteries, no zinc carbon
Non-rechargeable batteries cannot be charged.
Batteries should be placed in the correct polarity.
Do not short-circuit the power terminal.
When not in use please switch the product OFF completely
Do not place inside the cot or too close to the baby.
The plush can be washed by hand and air dried, but remove the module beforehand.
This product is intended for indoor use and is not water resistant.
Please keep dry.
For cleaning do not immerse in water, but wipe with a damp cloth.
The light does not get warm.
Do not try to disassemble the product if it stops working.
Please contact customer service.