1681822954_9917 Custom Built Hot Tub Cover
Product Information:
Our custom-made covers are designed specifically for your Hot
Tub/Spa. Please note that we cannot be held responsible for
incorrect measurements or misinformation provided by the customer.
By completing the ordering procedure, you are committing to
purchasing the cover as specified.
Measuring Guide:
A. Measuring Length & Width:
- When measuring your spa for a new cover, keep your tape measure
straight at all times. - We recommend taking measurements in at least 3 locations for
each dimension. - If dimension A and dimension B (length & width) are almost
identical, your spa is most likely a square spa. - If you are unsure about sizing, we suggest rounding up to the
nearest cm. Your cover will sit fine up to 2.5cm larger than your
dimensions.
R. Measuring Corner Radius:
- The easiest way to measure your corner radius is to use a
carpenter’s square. If unavailable, you can use a ruler and
straight edge. - Remember, the smaller the radius, the more square the corners
are. If you are unsure, smaller is safer!
C & D. Measuring the Straps:
- Our strap length is fully customizable to suit your spa and
cover. - Please specify the length required when completing your spec
sheet. - Measure from the underside of your cover down to the top of the
clip. - We provide 4 new locking clips.
S. Measuring the Skirt:
- The skirt is vital for retaining heat and protecting the
acrylic on your spa. - Ensure that the skirt is long enough to completely cover the
acrylic. - The skirt provides protection against UV rays to prevent any
fading of your acrylic/spa. - Keep in mind that spas sunk into decking may require a shorter
skirt.
Measuring Guide
S
Our covers are custom made to your specification.
We cannot be responsible for incorrect measurements or
misinformation provided by the customer. By completing the
ordering procedure you are committing to purchasing this
B
cover as you have specified.
Please make sure to take measurements from your Hot
Tub/Spa and not your existing lid as this may have stretched or
expanded over time.
A
Dimension A & B Length & Width
When measuring your spa for a new cover, be sure to keep your tape measure straight at all times, we suggest taking measurements in at least 3 locations for each dimension to be sure.
If dimension A and dimension B (length & width) are almost identical it is most likely your spa is a square spa.
If you are in doubt of any sizing we suggest rounding up to the nearest cm. Your cover will sit fine up to 2.5cm larger than your dimensions. It is better to have a cover that is slightly larger than too small.
R
C D
Dimension R – Corner Radius
The easiest way to measure your corner radius is to use a carpenter’s square, however if you don’t have one of these you can simply use a ruler and straight edge.
Remember the smaller the radius the more square the corners are. If you are unsure smaller is safer!
Dimension C & D – Measuring the straps
Our strap length is fully customisable to suit your spa and cover, please specify the length required when completing your spec sheet.
Be sure to measure from the underside of your cover down to the top of the clip.
We provide 4 new locking clips.
Dimension S – Measuring the skirt
The skirt is vital for retaining heat and protecting the acrylic on your spa.
Make sure to measure the skirt so that is long enough for it to completely cover the acrylic.
The skirt provides protection against UV rays to prevent any fading of your acrylic/spa.
Keep in mind that spas sunk into decking may require a shorter skirt.
Skirt length
