M6 Wireless Router
Product Information
The product complies with Part 15 of the FCC Rules and
Innovation, Science and Economic Development Canada’s
license-exempt RSSs. The device must not cause harmful interference
and must accept any interference received. The transmitter must not
be co-located or operating in conjunction with any other antenna or
transmitter. The product meets the FCC radiation exposure limits
and should be installed and operated with a minimum distance of 20
cm (7.88 inches) between the radiator and the user’s body. The
power supply unit input voltage is 100-240V, 50/60 Hz, 1A, and the
output voltage is 12.0V, 2A.
Product Usage Instructions
- Do not connect equipment during an electrical storm.
- Do not use the product near water.
- Do not locate the product near flame, ignition, or heat
sources. - Use only the power supply and/or power cord included with the
product. - Clean using only a dry, lint-free cloth. Do not use cleaning
agents or aerosols. - Install the product near the power outlet.
- If you are in a non-US country, select the country code
accordingly. Per FCC regulation, all Wi-Fi products marketed in the
US must fix to US operation channels only. - If you are in Canada, comply with CAN ICES-003(B) / NMB-003(B)
regulations. This equipment should be installed and operated with a
minimum distance of 20 centimeters (7.88 inches) between the
radiator and your body. - If you need open source software information, send your request
in writing to ARRIS, Software Pedigree Operations, 2450 Walsh
Avenue, Santa Clara, CA 95051, USA. You can also visit
opensource.arris.com for more information. - When disposing of the product, do not dispose of it with
residential or commercial waste. Some countries or regions have set
up systems to collect and recycle electrical and electronic waste
items.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
· Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Note: The country code selection is for non-US models only and is not available to all US models. Per FCC regulation, all Wi-Fi products marketed in US must fix to US operation channels only.
· This device is restricted for indoor use only.
· The operation of this device is prohibited on oil platforms, cars, trains, boats, and aircraft, except that operation of this device is permitted in large aircraft while flying above 10,000 feet.
· Operation of transmitters in the 5.925-7.125GHz band is prohibited for control of or communications with unmanned aircraft systems
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm (7.88 inches) between the radiator and your body.
CANADIAN COMPLIANCE
CAN ICES-003(B) / NMB-003(B)
This device complies with Innovation, Science and Economic Development Canada’s license-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance.
· Operation shall be limited to indoor use only; and
· Operation on oil platforms, cars, trains, boats and aircraft shall be prohibited except for on large aircraft flying above 10,000 ft.
Le dispositif rencontre l’exemption des limites courantes d’évaluation dans la section 2.5 de RSS 102 et la conformité à l’exposition de RSS-102 rf, utilisateurs peut obtenir l’information canadienne sur l’exposition et la conformité de rf.
· Utilisation limitée à l’intérieur seulement;
· Utilisation interdite à bord de plateformes de forage pétrolier, de voitures, de trains, de bateaux et d’aéronefs, sauf à bord d’un gros aéronef volant à plus de 10 000 pieds d’altitude.
Caution: This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a minimum distance of 20 centimeters (7.88 inches) between the radiator and your body.
Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en même temps qu’aucune autre antenne ou émetteur. Cet équipement devrait être installé et actionné avec une distance minimum de 20 centimètres (7,88 pouces) entre le radiateur et votre corps.
CAUTION: Important Safety Instructions
Do not connect equipment during electrical storm. Do not use product near water. Do not locate product near flame, ignition, or heat sources. Use only the power supply and/or power cord included with the product. Clean using only dry, lint-free cloth. Do not use cleaning agents or aerosols. Install product near the power outlet.
Ground coaxial cable shield at building/residence either close to point of entrance or at point of attachment. Ground as close as practical to building/ residence to minimize grounding connector length and reduce potential voltage differences between cable TV coaxial cable and other grounding system. Ensure coax cable attached to device is in good physical shape and properly tightened to unit. Do not block ventilation openings. Never stand it on soft furnishings or carpets. In areas with a high number of power surge events, additional power surge protection may be required.
Power supply unit
Input Voltage Output Voltage
This Class III product shall be powered by the Power Supply that is provided together with the product.
100-240V, 50/60 Hz, 1A
12.0V, 2A
Open Source Software Information
For instructions on how to obtain a copy of any source code being made publicly available by ARRIS related to software used in this ARRIS product you may send your request in writing to:
ARRIS, Software Pedigree Operations, 2450 Walsh Avenue, Santa Clara, CA 95051, USA
The ARRIS website opensource.arrisi.com also contains information regarding use of open source. ARRIS has created the opensource.arris.com site to serve as a portal for interaction with the software community-at-large.
Caring for the environment by recycling
When you see this symbol on an ARRIS product, do not dispose of the product with residential or commercial waste. Some countries or regions have set up systems to collect and recycle electrical and electronic waste items.
Recycling information can be obtained from the WEEE recycling section at www.CommScope.com.
Please recycle product packaging and this document.
© 2022 CommScope, Inc. All rights reserved. ARRIS and the ARRIS Logo are trademarks of CommScope, Inc. and/or its affiliates. All other trademarks are the property of their respective owners. No part of this content may be reproduced in any form or by any means or used to make any derivative work (such as translation, transformation, or adaptation) without written permission from CommScope, Inc. and/or its affiliates (“CommScope”). CommScope reserves the right to revise or change this content from time to time without obligation on the part of CommScope to provide notification of such revision or change. CommScope provides this content without warranty of any kind, implied or expressed, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. CommScope may make improvements or changes in the products or services described in this content at any time. The capabilities, system requirements and/or compatibility with third-party products described herein are subject to change without notice.
ARRIS, 3871 Lakefield Drive Suwanee, GA 30024, USA www.commscope.com
616641-034-01
M6 Use Steps a. Connect the M6 to your home router using the Ethernet cable provided. b. Connect the M6 to a power outlet using the power cable provided. c. Enter the user credentials (refer to the label on this card) on your 6GHz-capable devices to connect to the M6 AP. d. If you have another M6 acting as subordinate device, pushing the WPS (Sync) button of the M6 AP and the subordinate device together. They will get connected via Wi-Fi. e. The Xbox, PC or other devices connect to the subordinate M6 device via LAN port to access the internet.
CommScope | now meets next
CommScope | now meets next
CommScope | now meets next
