Hoselink 1003-wg Auto Fill Pet Water Bowl User Manual

User Manual
MODEL: 1003-WG
Auto-fill Pet Water BowlMODEL: 1003-WG
Auto-fill Pet Water Bowl

1003-WG Auto Fill Pet Water Bowl

Kit Contents

1 x Pet Bowl
1 x Float Valve
1 x Cover
1 x Hoselink Accessory Connector

Assembly

1. Open box and remove parts from inside bowl. Give the bowl a clean with soap and water.
2. Screw the Hoselink Accessory Connector into the float valve.

Connecting Water Supply

Note: To connect your hose with Hoselink fittings please refer to the website for fitting instructions.

1. Fill the pet bowl with water directly from the hose to about 2cm from the rim. This will save time.
2. Once filled, attach the Hoselink hose to the pet bowl and place the bowl on a flat horizontal surface.
3. Turn the tap on to start filling.
   Note: The bowl only requires very low water pressure to operate. Only turn tap on lightly.

Use with P.E.T. Drink Bottle

1. Fill pet bowl to 2cm from the rim.
2. Fill P.E.T. bottle with water. The bottle upside down and screw into the PET hole. For this step make sure you are in an area that can get wet.
3. The P.E.T. bottle will empty until it reaches the fill line. The water will then dispense out of the P.E.T. bottle whenever your pet drinks from the bowl.

For more information visit
hoselink.com.au
or call 1300 900 617
Cultivating Connections
youtube.com/hoselink

References

• Hoselink Products Australia | Garden Watering Systems