Shada 700501 Led Construction Safety Light Instruction Manual

Shada 700501 Led Construction Safety Light Instruction Manual

SHADA Logo700501 LED Construction Safety Light
Instruction Manual
SHADA 700501 LED Construction Safety Light - Fig 1

warning - 1 Warning

Warning icon Safety warning!
Ensure that you have fully read and understood the instructions in this document before you install or use the product following the installation/wire diagram (when applicable). Keep this document for future reference and only use the product as described in this document. Any other use of the product than described in this manual may damage the product or cause injury to the user (e.g. due to a short circuit, fire, or electric shock). Disconnect the product from the power source when problems occur. Do not drop the product and avoid bumping. Do not use the product if a part is damaged or defective. Replace a damaged defective product immediately. When a non-standard consumer (power)installation is required this should be performed by a qualified technician to reduce the risk of an electric shock. Make sure the product is sufficiently ventilated during use. Never cover an electrical (LED) device during usage since it can generate heat causing damage. Besides LED can be extremely bright and may cause serious eye damage so do not stare at it directly. When a product is meant for indoor and/or outdoor use only, this will be mentioned on the product/parts or in the manual. Keep the product out of reach of children or animals.

SHADA 190101 PIR 270 Degree IP44 Sensor - Icon 1 Cleaning and Maintenance Warning!

Do not use cleaning solvents or abrasives. Do not clean the inside of the device. Do not attempt to repair the device. Replace the device when it does not operate correctly. Clean the outside of the device using a soft damp cloth (Do not use a microfiber cloth).

SHADA 190101 PIR 270 Degree IP44 Sensor - Icon 2 Support

If you need further help or have comments or suggestions please visit www.shadamlinlicontact

SHADA 700501 LED Construction Safety Light - Icon 1A cover with damage must be replaced.
SHADA 700501 LED Construction Safety Light - Icon 3Do not stare at the light source.
SHADA 700501 LED Construction Safety Light - Icon 2Non-replaceable light source.
SHADA 700501 LED Construction Safety Light - Icon 4IP67-Housing – Products with IP66 are dust tight and protected against water jets.
WEE-Disposal-icon.pngThe item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment
CE SYMBOLThis product carries the CE mark which confirms that this product meets EU safety, health, and environmental protection requirements.
SHADA 700501 LED Construction Safety Light - Icon 5Class III — A Class III appliance is designed to be supplied from a separated extra-low voltage (SELV) power source.
Warning iconNOTE! Opening the device in any other way than described will void the warranty

D.O.C:

SHADA 700501 LED Construction Safety Light - Qr Code 2SHADA 700501 LED Construction Safety Light - Qr CodeSHADA 700501 LED Construction Safety Light - Qr Code 1

http://shada.nl/p/700500

http://shada.nl/p/700501

http://shada.nl/p/700502

SHADA LogoMolenmakershoek 28,
11-7328 JK APELDOOR11
The fatherlands
www.shada.nlSHADA 190101 PIR 270 Degree IP44 Sensor - Icon 3

Documents / Resouces

Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.


Related Manuals