Pyramid-30 Pyramid Wall Mount Range Hood

Product Information: PORTER&CHARLES (P&C) Range
Hood

The PORTER&CHARLES (P&C) Range Hood is a high-quality
kitchen appliance designed to effectively remove cooking fumes from
your kitchen while operating quietly. It is manufactured with
top-quality materials and features a streamlined design that adds
elegance to your kitchen. The range hood comes in two models:
Pyramid-30 and Pyramid-36, both with a power supply of 110-120V,
60Hz, airflow of 500 CFM, and an outlet diameter of 150mm. The
range hood also has a rated input power of 97W or 99W, depending on
the model, and a motor power of 95W. The lighting power for
Pyramid-30 is 1x2W, while Pyramid-36 has 2x2W lighting power.

Features

• High suction power and low noise
• Streamlined design
• Manufactured with top-quality materials

Installation Instructions

1. For safety and optimum performance, mount the range hood at a
   distance of 24 inches (600mm) from an electric or induction cooktop
   and 30 inches (762mm) above a gas cooktop. If the gas cooktop
   installation instructions specify a greater distance, follow those
   instructions. The exhaust air must not be discharged into a flue
   used for exhausting fumes from other appliances burning gas or
   other fuels.
2. To install onto the wall, drill two 8mm holes on either side of
   the center point of the range hood in a sturdy wall at 3.54 inches
   (90mm) distance. Mount the bracket on the wall in an appropriate
   place.
3. Insert expanding screws into the holes and fix the drilling
   template on the wall.
4. Add the duct (alternative part) and connect it to the kitchen
   outlet vent with screws.
5. Take out the inner chimney with the outer chimney together from
   the range hood.

Cleaning and Maintenance

1. Clean the surface of the range hood every week with mild soap
   or detergent, avoiding solvents, acid, alkali, scouring pads, or
   powder that could irreparably damage the stainless steel
   surface.
2. The grease filters may be washed using mild soap, detergent, or
   degreasing agents.
3. The filters can be washed in a dishwasher.
4. The charcoal filters cannot be cleaned and must be replaced
   after 6 months of use.

Specifications

Important Notes:

• The installation must be done by a qualified technician
  experienced in range hood installation.
• The manufacturer disclaims all liability for any damage or
  injury caused as a result of not following the installation
  instructions.
• The range hood is not intended for use by young children or
  infirm persons without supervision.
• Young children should be supervised to ensure that they do not
  play with the range hood.
• The maximum number of burners covered by a range hood should
  not exceed 5.
• Any modifications to the range hood, electric wire, and plug
  are dangerous and void the warranty.
• The range hood must not be installed closer than 24 inches
  (600mm) from an electric or induction cooktop and 30 inches (762mm)
  above a gas cooktop.
• The exhaust air must not be discharged into a flue used for
  exhausting fumes from other appliances burning gas or other
  fuels.
• The charcoal filters cannot be cleaned and must be replaced
  after 6 months of use.

PORTER&CHARLES (P&C) P&C
P&C

Installation Diagram

E

E

o

.a.,,..:…..,. =’rS-t

! o 0

= I ‘St

(0

!.f … . 480mm (19″)

-;;· :

141 Pa g e

Introduction
o This appliance has been manufactured with materials and processes that respect the environment. We hope that you will continue this important consideration in the operation of this appliance and the disposal of the packaging materials – thank you.
o The installation work must be undertaken by a qualified technician experienced in range hood installation. Please connect the correct power rating(see page 10).
o The manufacturer disclaims all liability for any damage or injury caused as a result of not following instructions for installation contained in the following text.
o The appliance is not intended for use by young children or infirm persons without supervision.
o Young children should be supervised to ensure that they do not play with the appliance.
o The maximum number of burners covered by a range hood should not exceed 5.
o Any modifications to the appliance, electric wire and plug is dangerous and voids the warranty.
Features
o This appliance is manufactured from top quality materials, and offers superb streamlined effects.
o With high suction power and low noise, it is designed to remove cooking fumes from your kitchen quietly and effectively.
3IPa g e

Installation (duct is not supplied)
1. The range hood should be mounted at a distance of 24″ (600mm) from an electric or induction cooktop, and 30″ (762mm) above a gas cooktop for safety and optimum performance (see pie 1). If the instructions for installation of the gas cooktop specify a greater distance, this has to be taken into account. The exhaust air must not be discharged into a flue which is used for exhausting fumes from other appliances burning gas or other fuels.
2. To install onto the wall, drill 2 holes of <I>8mm in a sturdy wall 3. 54’ c90mm> on either side of centre point of range hood. And mount the bracket on the wall in an appropriate place (see pie 2).
3. Insert expanding screws into the holes (see pie 2). 4. Fix drilling template on the wall. 5. Add the duct (alternative part) and connect it to the kitchen outlet
vent with screws (see pie 3). 6.Take out the inner chimney with outer chimney together from the
package. Pick out one of the brackets from the accesories. Using two screws M4X8 to lock the bracket on the outer chimney top (see pie 6 ). 7. Put outer chimney and inner chimney together on the main body (see pie 4). Pull out the inner chimney and fix the inner chimney to the bracket by screws. Then insert the outer chimney, the outer chimney should be fixed on the main body by screws (see pie 5). 8. Ensure that the wall the hood is to be installed on is sufficiently sturdy to carry the weight of the hood. It should be mounted level for best performance. 9. Do not connect to a common vent with any other appliances such as a gas heater, water heater, washer/dryer,etc. 10. The duct should not be bent more then 120° from the one way valve outlet in the kitchen vent. 11.Check to make sure that the electrical cord is not in contact with sharp edges of the appliance. 12.Be sure that the plug is accessible after installation.
4IPage

Cleaning & Maintenance
1. Clean the surface of the hood every week with mild soap or detergent. Avoid solvents, acid, alkali, scouring pads or power that could irreparably damage the stainless steel surface.
2. The grease filters may be washed using mild soap, detergent or degreasing agents.
3. The filters can be washed in a dishwasher. 4. The charcoal filters cannot be cleaned and must
be generally replaced after 6 months of use.
13IPage

Specifications

Pyramid-30 Power Supply Rated Input Power Lighting Power Motor Power Airflow Outlet Diameter Hardwire or Plug
Pyramid-36 Power Supply Rated Input Power Lighting Power Motor Power Airflow Outlet Diameter Hardwire or Plug

110-120V, 60Hz 97W 1x2W 95W
500 CFM 150mm
Plug
110-120V, 60Hz 99W 2x2W 95W
500 CFM 150mm
Plug

12IP a ge

13. For ductless installations (or recirculation instruction), remove the label on the underside of the hood indicating installation of a charcoal filter. Attach charcoal filter, part CF-B, by placingin openingand clippingin place.

Pie 1 Pic6

5IP a ge

Grounding Instructions
o This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.
o Warning – Improper grounding can result in a risk of electric shock.
o Consult a qualified electrician if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded.
o Do not use an extension cord. If the power supply cord is too short, have a qualified electrician install an outlet near the appliance.
WARNING: TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK AND DUCT CONNECTION DEVICE.
Bl Pa g e

Safety Information
o There must be permanent and adequate ventilation of the room when operating the range hood with appliances burning gas or other fuels.
o Do not check the status of the filters when the range hood is operating – wait at least 30 minutes after switching off to avoid scalding.
o Do not touch the LED light within 30 minutes after appliance use.
o Avoid operating a gas cooktop when there is no pan on the stove. It is a fire hazard and may cause damage to the hood filters.
o Disconnect the electrical plug prior to any maintenance.
o This appliance is not intended for use by young children unless they have been adequately supervised by a reasonable person to ensure that they can use the appliance safely.
o The range hood is for home use only and is not suitable for outdoor, barbeque, and other commercial applications.
o The range hood and its filter should be cleaned regularly for best performance.
o Before cleaning, please confirm that the power is switched off.
o Building regulations concerning the discharge of exhaust air have to be fulfilled.
o Do not cook with an open flame under the range hood. o For any technical issues ensure that a suitably
qualified person handles any repairs or inspections.
91Pa g e