Wooden Wall Hook
Product Information:
- Product Name: Wooden Wall Hook Kroft
- Included Hardware:
- Hanger Bolt
- Drywall Anchor
- Recommended Tools:
- Drill
Product Usage Instructions:
- Measure and mark the desired height of the hook on the
wall. - Using a drill bit, drill a hole through the wall at the desired
height. - TIP: When drilling the hole, be sure to keep the drill bit
level. This will ensure the hook is mounted flush to the wall. - Insert the drywall anchor into the drilled hole.
- A hammer may be used to gently tap the anchor until it is flush
with the wall, taking care not to drive the collar of the anchor
beneath the surface of the wall. - Insert the flat end of the hanger bolt into the back of the
hook. Twist it into place until half of the hanger bolt remains
visible. - Insert the hook into the drywall anchor. Twist it until it is
flush with the wall. - Twist the hook to the desired orientation. The hook may be
positioned vertically or horizontally. - TIP: The hook may rotate with rough use or if used to hang
items on the component parallel to the wall. To prevent the hook
from rotating, an adhesive such as an epoxy or suitable glue can be
applied between the back of the hook and the wall to set the hooks
in the desired position. - Done!
WOODEN WALL HOOK KROFT
3″ 4″
ø ¾” ø 1″
INCLUDED HARDWARE:
Hanger Bolt
Drywall Anchor
RECOMMENDED TOOLS:
Drill
1. Measure and mark desired height of hook on wall.
2. Using a /” drill bit, drill a hole through wall at desired height.
TIP When drilling the hole, be sure to keep the drill bit level. This will ensure the hook is mounted flush to the wall.
3. Insert drywall anchor into the drilled hole.
A hammer may be used to gently tap the anchor until it is flush with the wall, taking care not to drive the collar of the anchor beneath the surface of the wall.
4. Inser t flat end of hanger bolt into the back of the hook. Twist into place until half of the hanger bolt remains visible.
5. Insert hook into drywall anchor. Twi st u n til fl u s h w ith w a l l .
6. Twist hook to desired orientation. Hook may be positioned vertically or horizontally.
TIP
The hook may rotate with rough use or if used to hang items on the component parallel to the wall.
To preve n t th e h o o k f rom rotating, an adhesive such as an epoxy or suitable glue can be applied between the back of the hook and the wall to set hooks in desired position.
Done!
