Baby Lock Single Fold Bias Binder Instructions

baby lock Single Fold Bias Binder

KALORIK-AFO-52352-SS-Digital-Air-Fryer-Toaster-Oven-fig- 4

The Single Fold Bias Binder is a conventional binder designed for use with the Baby Lock Serger. It allows you to double fold and sew bias strips to your project in one quick step using either a chain or cover stitch. The Single Fold Bias Binder comes in two widths: 1-1/8 inch (28mm) and 1-5/8 inch (40mm), allowing you to choose based on your preference.

Machine Settings

• Stitch type: 1-5/8 Wide Cover Stitch C1-C3, Triple Cover Stitch C1-C2-C3
• Stitch length: 3-4
• Upper looper: Down
• Cutting blade: Disengaged (LOCKED)
• Sewing table: On
• Sewing speed: Moderate to slow
• Fabrics used: Broadcloth, chambray, lace (width of bias strip), lightweight denim

Cutting Width of Bias Strips

• 1-1/8 inch (28mm): Cut bias strip 1-3/8 inch wide
• 1-5/8 inch (40mm): Cut bias strip 1-5/8 inch wide

Note: Heavier fabrics may require narrower bias strips.

Product Usage Instructions

1. Secure the attachment to the table with the guide fixing  screws.
2. Feed the bias strip into the attachment with the wrong side facing you.
3. Using tweezers, pull the folded bias strip into the attachment.
4. Continue pulling until the bias strip reaches the needles and is under the presser foot.
5. Take a few stitches to secure the fabric.
6. Ensure that the alignment of the attachment is in place with the needle position. The needle should be sewing in the doubled fold on top of the fabric.
7. Perform a test sew to ensure proper alignment before sewing on Nyour project.

Baby Lock Sashiko Accessories – Single Fold Bias Binder

The Single Fold Bias Binder is also compatible with the Baby Lock Sashiko machine. The usage instructions for the Sashiko machine are similar to those for the Baby Lock Serger, with slight differences in machine settings.

Machine Settings (Sashiko Machine)

• Stitch length: 2-5mm
• Stitch space length: 2-5mm
• Sewing speed: Moderate to slow
• Fabrics used: Broadcloth, chambray, lace (width of bias strip), lightweight denim

Note: Heavier fabrics may require narrower bias strips.

Product Usage Instructions (Sashiko Machine)

1. Secure the attachment to the base of the machine with the guide fixing screws.
2. Feed the bias strip into the attachment with the wrong side facing you.
3. Using tweezers, pull the folded bias strip into the attachment, up to the needles and under the presser foot.
4. Take a few stitches to secure the fabric.
5. Ensure that the alignment of the attachment is in place with the needle position. The needle should be sewing in the doubled fold on top of the fabric.
6. Perform a test sew to ensure proper alignment before sewing on your project.