Vaxcel C0275 Integrated Led Chrome Flush Mount Ceiling Light Fixture Clear Bubble Acrylic Shade Instruction Manual

C0275 Integrated LED Chrome Flush Mount Ceiling Light Fixture Clear Bubble Acrylic Shade

Product Information

The product is a light fixture with the model number C0275. It
comes with an assembly kit that includes an outlet box, a mounting
strap unit (A), mounting screw (B), wire connector (C), and finial
(D). The fixture has a dimming range from 100% full illumination to
10% of full illumination.

Product Usage Instructions

1. Turn off the power at the fuse or circuit box.
2. Attach the mounting strap unit (A) to the outlet box using two
   mounting screws (B).
3. Pull out the source wires from the outlet box and connect them
   to the fixture wire using wire connectors (C). Connect the fixture
   ground wire to the house ground wire with the wire connector
   (C).
4. Put all of the wires back into the outlet box.
5. Attach the ceiling plate to the mounting strap unit (A) by
   inserting the threaded pipe from the mounting strap unit (A) into
   the center hole on the ceiling plate, then secure the ceiling plate
   with finial (D).
6. Turn on the power at the fuse or circuit box.

Note: Before installation, consult local electrical codes for
wiring and grounding requirements. Also, be sure to shut off power
before installing or servicing this fixture. Read and save these
instructions. If any parts are damaged or missing, refer to the
spare parts list and order an assembly kit 6595MM which includes a
mounting strap unit (A), mounting screw (B), wire connector (C),
and finial (D).

ASSEMBLY AND INSTALLATION INSTRUCTIONS
C0275
WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.

Hardware Package (included):

Outlet Box

Mounting Strap Unit (A) Mounting Screw (B) Wire Connector (C) Finial (D
Installation Steps
Turn off the power at fuse or circuit box.

House Ground Wire Hex Nut Washer Mounting Strap Unit (A) Green Ground Screw Mounting Screw (B) Threaded Pipe
Wire Connector (C)
Fixture Wire
Fixture Ground Wire

1. Attach the mounting strap unit (A) to the outlet box by using two mounting screws (B). Note: The depth of threaded pipe on the mounting strap unit may need to be adjusted to properly fit the fixture.

Ceiling Plate Finial (D)

2. Pull out the source wires from the outlet box.

Make wire connections using wire connectors (C)

as follows:

· Connect the hot wire (black insulation) from the

DD

fixture to the black wire from the power source.

· Connect the neutral wire (white insulation) from the fixture to the white wire from the power source.

· Attach the fixture ground wire (bare wire) to the mounting strap unit (A) with the green ground screw,

then depending on local code, connect it to the house ground wire with the wire connector (C).

Carefully put all of the wires back into the outlet box.

3. Attach the ceiling plate to the mounting strap unit (A) by aligning and inserting the threaded pipe from the mounting strap unit (A) into the center hole on the ceiling plate, then secure the ceiling plate with finial (D).

Turn on the power at fuse or circuit box.

Note: Dimming range: 100% full illumination to 10% of full illumination.

221021

The following parts are available for re-order if damaged or missing.
Spare Parts List:
Assembly Kit 6595MM (1 SET)
Mounting Strap Unit (A) Mounting Screw (B) Wire Connector (C) Finial (D

A

A: 3-1/2″

B: 12″

B

221021