Brita S01zh7973j Elite Water Filter Replacements For Pitchers And Dispensers User Guide

BRITA S01ZH7973J Elite Water Filter Replacements for Pitchers and Dispensers

INSTALLATION INSTRUCTION

1. Hand wash* pitcher/dispenser, lid, and reservoir. Rinse well. With clean hands, insert the filter into the reservoir by lining up the groove in the filter with a ridge in the reservoir. Press firmly for a tight seal.
   • Do not wash in the dishwasher.
   • Do not use abrasive cleaners.
2. To set the filter life status indicator, press the STATUS button and hold it down for 6 seconds until the green light next to ELITE FILTER blinks three times.
3. Open the lid and fill the reservoir with cold tap water.* Pour out the first 3 pitchers/first dispenser of water, or use to water plants.
   • Hot water shouldn’t be used with the Brita® Elite™ Filter (Max. 85°F/29°C – Min. 32°F/0°C).
4. To check the filter life status, quickly press and release the STATUS button. When the light blinks red, you should replace your filter and reset the indicator (step 2), about every 6 months* for the average household.
   • Approximate timing based on 120 gallons (454 liters) filter life and average family usage of 11 glasses per day

PERFORMANCE

• For more information, including certified contaminant reduction claims, Performance
• For data Sheets and warranty information, please visit brita.com/performance-data or call 1-800-24-BRITA.
• Canada: Visit brita.com/performance-data or call 1-800-387-6940.
• You may need to change your filter more or less often than 6 months/120 gallons (454 L), depending on the amount and quality of the water you consume. For water with high levels of sediment, sand, and/or rust, the Brita® Elite™ filter may need to be changed more frequently to maintain the flow rate.
• We recommend that you keep your Brita® system out of direct sunlight and replace any filtered water that’s been left sitting for several days or more.
• For best results when filling the pitcher/dispenser reservoir, direct the flow of tap water on the side of the reservoir rather than directly on top of the filter.
• Only keep the lid open for more than 5 seconds if you are filling your pitcher/dispenser because this activates the filter change indicator, which measures water use by counting the number of reservoirs filled.
• The pitcher/dispenser works with all Brita® system filters except Stream.
• Visit brita.com/performance-data to find the full list of contaminants reduced, sign up for filter reminders, earn points, claim rewards, and more!

References

• Brita Canada
• brita.com/performance-data