Ari Kitchen Bath Carlsbad 36 Floating Vanity Installation Guide

Product Information

The Carlsbad 36 Floating Vanity is a stylish and functional
vanity unit designed for installation in bathrooms. It has the
following dimensions:

• Overall Width: 910mm [35.8 inches]
• Overall Depth: 560mm [22.0 inches]
• Overall Height: 470mm [18.5 inches]
• Water Inlet: 384mm [15.1 inches] from the left
• Drain: 515mm [20.3 inches] from the left
• Warning: Please be careful to avoid internal cables and
  pipelines when installing in the wall.

Materials & Tools Required

• Safety glasses
• Pencil
• Level
• Tape measure
• Stud Finder
• Assorted screwdrivers
• Assorted wrenches
• Drill
• Screw gun
• Caulking gun
• Hammer
• Screws
• Nail anchors/Molly screws

Product Usage Instructions

Vanity Installation

1. Ensure you have all the necessary materials and tools mentioned
   above.
2. Using a tape measure, mark the desired location on the wall for
   the vanity installation.
3. Use a stud finder to locate and mark the position of the wall
   studs.
4. Position the vanity against the wall, aligning it with the
   marked location.
5. Use a level to ensure the vanity is straight and adjust if
   necessary.
6. Secure the vanity to the wall by driving screws through the
   back of the vanity and into the wall studs.
7. Apply silicone sealant along the edges of the vanity to create
   a watertight seal.
8. Allow the silicone to dry as per the manufacturer’s
   instructions.

Drain Installation

1. Ensure you have the drain installation materials mentioned
   above.
2. Insert the drain body into the designated hole in the
   vanity.
3. Place a rubber washer over the drain body from underneath the
   vanity.
4. Screw on the lock nut onto the drain body from underneath the
   vanity and tighten it securely.
5. Attach the brass tube to the drain body from above the
   vanity.
6. Place another rubber washer over the brass tube from above the
   vanity.
7. Tighten the brass tube securely using a wrench.

Warning: Please be careful to avoid internal cables and
pipelines when installing in the wall.