Nedis Bttc200bk Bluetooth Transmitter Receiver User Manual

Preface

Product description

Intended use

Specifications

Main parts (image A)

A

Safety instructions

• Ensure you have fully read and understood the instructions in this document before you install or use the product. Keep this document for future reference.
• Only use the product as described in this document.
• Do not use the product if a part is damaged or defective. Replace a damaged or defective product immediately.
• Do not drop the product and avoid bumping.
• This product may only be serviced by a qualified technician for maintenance to reduce the risk of electric shock.
• Disconnect the product from the power source and other equipment if problems occur.
• Do not expose the product to water or moisture.
• Do not dismantle, open or shred secondary cells or batteries.
• Do not expose cells or batteries to heat or fire. Avoid storage in direct sunlight.
• Retain the original product literature for future reference.
• Do not leave a battery on prolonged charge when not in use.
• After extended periods of storage, it may be necessary to charge and discharge the cells or batteries several times to obtain maximum performance.
• Batteries contain explosive gases. Prevent contact with flames and sparks. Provide adequate ventilation during charging.
• Some wireless devices may interfere with implantable medical devices and other medical equipment, such as pacemakers, cochlear implants and hearing aids. Consult the manufacturer of your medical equipment for more information.
• Do not use the product at locations where the use of wireless devices is prohibited due to potential interference with other electronic devices, which may cause safety hazards.

Safety symbols on the product

Icon	Description
	Electronic equipment needs to bear the CE mark in order to be marketed in the EU. CE marking shows that a product is assessed before being placed on the market and that it meets EU safety, health and environmental protection requirements. CE marking is also sometimes accepted as a means of compliance with type-approval requirements; for example, electronic components that require type-approval and also CE marking for electromagnetic compatibility (EMC) or low-voltage equipment.
	Indication to explain that the product needs to be collected separately when disposed. Do not throw in the trash bin.

Installation

• Check the contents of the package
• Check that all parts are present and that no damage is visible on the parts. If parts are missing or damaged, contact the Nedis B.V. service desk via the website: www.nedis.com.

Charging the product

• A6 Burns red to indicate that the product is charging.
• A6 switches off when the battery is fully charged.
• When the battery is low, there is a prompt sound and A6 blinks red.

Switching the product on/off

• The product automatically switches off when it is not paired within 10 minutes.

Use

Receiver mode (image B)

B

• You can also connect an audio device with the stereo audio cable 2x RCA male to 3.5 mm female A12.

• Press and hold A4 to turn the volume up.
• Press and hold A2 to turn the volume down.
• A6 Blinks blue.

• If asked, enter the pairing code ‘0000’.
• A6 blinks slowly to indicate pairing is successful.

Transmitter mode (image C)

C

• You can also connect an audio device with the stereo audio cable 2x RCA male to 3.5 mm female A12.

• A6 Blinks green.

• Pairing time will vary depending on the device used.
• A6 Burns to indicate pairing is successful.

Connect a second device

• The devices must be one meter apart from each other.
• The two devices are connected simultaneously.
• If the pairing does not work, switch the product off and on.

Disconnect paired devices

• Press and hold A5 for 3 seconds.
• To disconnect a single device, switch off the Bluetooth of that device.
• To clear the pairing list press and hold A5 for 8 seconds.
• A6 Blinks twice when cleared.

Recommendations

• When connecting with two devices, use the devices with the same version of Bluetooth.
• In Bluetooth transmit mode, only headphones and similar devices can be connected. Smartphones cannot be paired with this mode.
• Do not use this product in a place with obstructions or other Bluetooth devices to avoid interference.
• When pairing fails, clear the list of paired devices on the product.

Maintenance

•  Clean the product regularly with a soft, clean, dry cloth. Avoid abrasives that can damage the surface.
• Do not use aggressive chemical cleaning agents such as ammonia, acid or acetone when cleaning the product.

Warranty

Disclaimer

Disposal

This symbol indicates that this product should not be thrown away with other household waste throughout the EU. To prevent possible harm to the environment or human health by uncontrolled waste disposal, you are responsible for recycling it so that it can promote the sustainable reuse of raw materials. To return your used product, you can use the regular return and collection systems or contact the store where the product was purchased. They can recycle this product for the environment.

Declaration of Conformity