SUPER COMBO 5500
DIRECTIONS FOR USE
INSTALLATION
- Remove 3 Shipping Rod on the back panel. This releases a red tag to free the power cord
- Connect Hot & Cold water hoses (included)
- Plug power cord into 110V/60Hz outlet 15 Amp outlet
- Insert the hose into U-connector and insert into a standpipe or over sink 24″- 40″ high
- Attach 4″ vent hose (included) on the back exhaust outlet if venting option will be used
- Venting/Condensing drying option – Press button for 5 seconds to select option (One-time setup)
OPERATIONS
- Load the machine to a maximum of 2/3 full
- Press POWER button on – Machine automatically goes to WASH & DRY Normal cycle – Press START
- To select other options, Press WASH+DRY, WASH Only, DRY Only.
Turn the knob to select a cycle. Press START
LAUNDRY TIPS
- DETERGENT: Use HE Detergent, Equator’ is recommended – 1 tablespoon
- FABRIC SOFTENER: Downy is recommended to reduce wrinkles and dry faster
- DELAY START: Press to delay start time up to 24 hours
NOTE:
- In condensing dryer mode, fabrics will be damp to the touch when unloaded but will air dry quickly
- Over-Drying will cause wrinkles
- Use Refresh function after the end of the Dryer cycle to reduce wrinkles
| Wash Times | Approx Dry Times | |
| Cycles | Mins | Mins |
| NORMAL | 51 | 90 |
| Prewash + Heavy | 75 | 120 |
| Heavy | 61 | 120 |
| ECO | 31 | 80 |
| Quick 20 | 20 | 80 |
| Delicate | 36 | 80 |
| Wool | 36 | TUMBLE ONLY NO HEAT |
| Quiet | 31 | 80 |
| Allergen | 59 | 120 |
| Sanitize | 69 | 120 |
| Winterize | 2 | NA |
| DIAGNOSTIC MENU | ||
| Code | Description | Component |
| El | Door open | Door Switch |
| E2 | Drain failure | Drain Pump |
| E3 | Water inlet failure | Inlet Valves |
| E4 | Water overfill | Pressure Switch |
| ES | Motor failure | Motor +Electronic Module |
| E7 | Washing heater failure | Washing heater |
| E8 | Dryer Malfunction | Temp. sensor (@rear-bottom of the tub) |
| E9 | Dryer Malfunction | Temp. sensor (@front of heater housing) |
| E10 | Water level failure | Water level sensor |
| E11 | Dryer Malfunction | Temp. sensor (near the blower fan motor) |
| E12 | Dryer Malfunction | Fan Motor |
| E13 | Dryer Malfunction | Dying heater |
| E16 | Communication between display & electronic module | Communication Cable |
QUESTIONS / SERVICE
Phone/Text : 1-800-776-3538
Email: [email protected]
