TWS Wireless Bluetooth Earbuds User Manual - Manualsee

TWS Wireless Bluetooth Earbuds User Manual

TWS

TWS Wireless Bluetooth Earbuds User Manual

TWS Wireless Bluetooth Earbuds
TWS Wireless Bluetooth Earbuds

Functional Diagram

TWS-Wireless-Bluetooth-Earbuds-diagram

How to Use

TO CHARGE CHARGING CASE
  1. Connect the lightning cable to lightning port on the charging case
  2. Plug the USB connnector of the cable into a USB Power source
  3. The indicator light will show RED while the charging case is charging,Depending on the power delivered to the charging case, the charging case will take approximately 2 hours or more to completely charge
  4. The indicator light will go solid blue, then blink, then turn off when the case is fully charged.
TO CHARGE EARPHONES
  1. Put the earphones in the charging case correctly, charging case will start to charging automatically
  2. The indicator light on the earphones will turn RED while charging
  3. The indicator light on the earphones will turn OFF when fully charged
POWER ON

Press and hold the multi-function key on BOTH L and R earphone for 3 seconds simultaneously, release when the BLUE light is on with a voice prompt:“POWER ON”

PAIRING
  1. When power on, L and R earphones will connect each other automatically and sound with a voice prompt: “ CONNECTED” , and the indicator lights of R earphone will flash blue and red with a voice prompt: “PAIRING”, While blue indicator light of L earphone flash slowly (*).
    TWS-Wireless-Bluetooth-Earbuds-02
  2. Enable the bluetooth pairing mode on your phone device. Tap on “Air plus” to connect. Right earphone will response with a voice prompt: “CONNECTED”and blue light flash when connected successfully.
    TWS-Wireless-Bluetooth-Earbuds-3
  3. Earphones will response with a voice prompt:“DISCONNECTED” when bluetooth signal is cut off, and shutdown 5mins later automatically
  4. When power on,the earphones will connect the last paired mobile automatically. If not, pls repeat step 2.

NOTE: IF you see 2 Airplus entries in available devices then the earphones are not paired correctly. Pls follow below steps to get it paired correctly *Both L and R earphones are well paired before it leaves the factory, Right earphone is the Main-headset by default, thus you may connect with your bluetooth devices directly. If they are not paired or reset to defaults, you need to pair 2 earphones manually as below steps:

  • a. Press and hold the multi-function key for 6 seconds of both earphones simultaneously, release when the indicator lights turn in red and blue, and response with a voice prompt: “PAIRING”, then they will be paired and connected automatically and response with a voice prompt: “CONNECTED”
  • b. When paired successfully, the indicator lights of R earphone will flash alternately in blue and red, While blue indicator light of L headsetflash slowly
  • c. Go back to step 2 to connect with your devices.
SINGLE EAR FOR INDEPENDENT USE
  1. Press and hold the multi-function key for 6 seconds on either earphone (base on your personal preference), release when the red and blue light flash alternately
  2. Enable your phone’s Bluetooth pairing function and search for the “Air plus”to pair and connect.
POWER OFF
  1. TWS mode (Due-ear)Press and hold the multi-function key on either earphone for3 seconds. Release when the red indicator light is on with a voice prompt:“POWER OFF”
  2. Independent use mode (Single Ear, L or R)Press and hold the multi-function key on the used earphone for 3 seconds. Release when the red indicatorlight is on with a voice prompt:“POWER OFF”
  3. Put the earphones in the charging case correctly, will auto shutdown * The battery status of earphones is visible on connected devices, when it’s running out of power, the earphones will remind you with a voice prompt:
    “LOW BATTERY, PLEASE CHARGE”, pls recharging in time
PHONE & MUSIC
  • To Answer A Call
    Press the multi-function key of the right earphone one short
  • To End A Call
    Press the multi-function key of the right earphone one short. Voice response
    tone“call ended”
  • To Reject A Call
    Press and hold the multi-function key of the right earphone for 1s. Voice response tone“call rejected”
  • To Redial A Call
    Press the multi-function key of the right earphone twice, Voice response tone “redialing”
  • To Play and Pause Music
    Press the multi-function key on either earphone once
  • To Play the next song
    Press and hold the multi-function key on either earphone for 2s
OUTDOOR USE

*Right headset is the Main-headset by default

TWS-Wireless-Bluetooth-Earbuds-4

Right earphone receiving mobile bluetooth signal suggest puting mobile in right pocket. This can avoid signal cut off by human body and increase antijamming capability of outdoor use.

Specification

NoItemSpecification
1Frequency response range20HZ-20KHZ
2Product impedance(160) 320 ± 15%
3Sensitivity103 +3dB At 1000 Hz   At 0.126V
4Product Size43.Sx 17.2x 1B.5 (mm)
5Bluetooth receiving distance12 meters (standard environment)
6Weight7.Gg (Not including storage box)
7Bluetooth version 4.2
8Transmission range2402-2480MHz
9Supporting agreementHSP/HFP/A2DP(SBC,AAC)/AVRCP
10Transmission  frequency 2.4GHz band (2.4000-2.4835GHz)
11Charging time45 minutes ( earphone )
12Life timeTalk time: about 3.5 hours

 

Music Play time: About 120 minutes(maximum volume)

Standby time: About 80 hours

13Charging voltage/ current5V1A
14Product working temperature– 100C-500C
15Product storage temperature-200C-650C

Safety Precautions

Please read follow and keep these instructions:

  1. Keep the device out of extreme heat and humid
  2. Power time may different depending on personal habits
  3. Heed all warnings on the product and in the operation instructions
  4. Do not listen at high volume level for long period to protect hearing
  5. Stop using this product immediately if it causes discomfort or pain

Inside the box

  1. Bluetooth Headset X 2PCS
  2. Charging Case X1PCS
  3. USB lightning charging cable X1PCS
  4. User Manual X1 PCS

FCC Warning Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. the user is encouraged to try to correct the interference by one or more of the following measures

  • Reorient or relocate the receiving antenna
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
  • Consult the dealer or an experienced radio/TV technician for help.

FAQS

How do i charge them? do i plug the case in while charging or what? lid opened or closed?

The case has a battery that will need to be occasionally charged. The earbuds will charge whenever they’re in the case, regardless of the lid position.

The right ear bud keeps saying “please charging”? I assume this means “please charge me”. Even after hours of charching it still says it.

You might have to do a factory reset that’s what I did. Put earbuds in case leave open hold button down in the back of the case for 10 seconds. Then pair again both ear buds should start working now.

Will they work with my lg tv?

If you’re LG TV has options to pair Bluetooth devices I would say they should work.

Why does my right earbud produce no sound?

You might have to do a factory reset that’s what I did. Put earbuds in case leave open hold button down in the back of the case for 10 seconds. Then pair again both ear buds should start working now.

Playtime 4 hrs but 18 with case. What’s that mean exactly? Can you wear/listen and charge at same time?

No, you have to plug them into the case and the case charges them. They charge pretty fast though. 20 min charge will get you at least another hour or two

How do you charge the case

It has a USB-C jack. You plug a charger into it like you do a phone.

What’s the range of these earbuds away from the device?

About 10 meters… I’ve left my phone in my kitchen at one end of my house and went all the way back to the other end of the house and never lost connection…. i have a 2000 sq/ft house…. I haven’t tried going any further than that outside though… I am pretty impressed with these little earbuds!

Can these be used without wifi on a plane?

Sure Bluetooth doesn’t need wifi!

each ear bud shows up as a different device, i can’t get them to pair together. they weren’t doing this previously how do i stop this?

Make sure they are both charged. Make sure your case has at least 50%. Do a factory reset

Do this earbud have microphone? Can i answer phone call?

Yes, you can use these to take calls. There is a mic.

How you advance next song ?

Press twice on the right earbud

TWS Wireless Bluetooth Earbuds User Manual – Download [optimized]
TWS Wireless Bluetooth Earbuds User Manual – Download

Other top TWS’s manuals:

TWS

TWS Wireless Bluetooth Earbuds
Click to Read More TWS’sManuals


Related Manuals