DD1-21 5.8 Cu. Ft. White Upright Freezer
Product Information
This product is a door hinge bracket and stopper kit. It is
designed to be used with doors and helps in aligning and securing
them properly. The kit includes a hinge bracket, door stoppers,
hinge cover, and screw cover.
Product Usage Instructions
- Remove the top right hinge cover by gently pulling it off.
- Undo the screws holding the hinge bracket in place. Once the
screws are removed, carefully detach the hinge bracket from the
door. - Locate the door stopper on the bottom right side of the door
and remove it. - From the accessory bag, find the left side door stopper and
install it on the bottom left side of the door. Make sure it is
securely attached. - (Optional steps 6-9 are missing in the provided text)
- Put the hinge cover back in its original position by aligning
it properly and pressing it firmly until it snaps into place. - Similarly, put the screw cover back by aligning it with the
screw holes and pressing it until it is securely attached. - Close the doors and check if they are aligned horizontally and
vertically. Ensure that the seal is closed on all sides. - If necessary, tighten the bottom hinge to ensure proper
alignment. Use a suitable screwdriver to tighten the screws. - If needed, re-adjust the leveling feet to ensure stability and
balance.
Note: Steps 6-9 are missing in the provided text, so please
refer to the complete user manual for detailed instructions on
those steps.
1.Remove the top right hinge cover.
2.Undo the screws.Then remove the hinge bracket.
5.Remove the door stopper from the bottom right side of the door. Find the left side door stopper in the accessory bag and install it on the bottom left side of the door.
6.
7. Refit 8
9.
10.
11.
12.Put the hinge cover and the screw cover back.
13. With the doors closed,check that the doors are aligned horizontally and vertically and that the seal is closed on all sides before finally tightening the bottom hinge.Re-adjust the levelling feet as needed.
