Bissell POWERFORCE HELIX TURBO Vacuum User Guide

POWERFORCE HELIX TURBO Vacuum

POWERFORCE® HELIX™ TURBO
Vacuum

USER GUIDE
2190 SERIES

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE USING YOUR UPRIGHT VACUUM.
Always connect to a polarized outlet (one slot is wider than the other). Unplug from outlet when not in use and before conducting maintenance. When using an electrical appliance, basic precautions should be observed, including the following:

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY:
» Do not leave vacuum when it is plugged in. Unplug from outlet when not in use and before servicing.
» Do not use outdoors or on wet surfaces.
» Do not allow to be used as a toy. Close attention is necessary when used by or near children.
» Do not use for any purpose other than described in this user guide. Use only manufacturer’s recommended attachments.
» Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, have it repaired at an authorized service center.
» Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
» Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
» Do not handle plug or vacuum with wet hands.
» Do not put any object into openings. Do not use with any opening blocked; keep openings free of dust, lint, hair, and anything that may reduce air flow.
» Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
» Turn OFF all controls before plugging or unplugging vacuum.
» Use extra care when cleaning on stairs.
» Do not use to pick up flammable or combustible materials (lighter fluid, gasoline, kerosene, etc.) or use in areas where they may be present.
» Do not use vacuum in an enclosed space filled with vapors given off by oil-based paint, paint thinner, some moth-proofing substances, flammable dust, or other explosive or toxic vapors.
» Do not use to pick up toxic material (chlorine bleach, ammonia, drain cleaner, etc.).
» Do not pick up anything that is burning or smoking, such as cigarettes, matches or hot ashes.
» Do not use without filters in place.
» Do not pick up hard or sharp objects such as glass, nails, screws, coins, etc.
» Use only on dry, indoor surfaces.
» Keep appliance on a level surface.
» Do not carry the vacuum while it is running.
» Unplug before connecting or disconnecting the TurboBrush® Tool.

SAVE THESE INSTRUCTIONS

This model is for household use only.

  WARNING

» Plastic film can be dangerous. To avoid danger of suffocation, keep away from children.
» Do not plug in your vacuum UNTIL you are familiar with all instructions and operating procedures.
» To reduce the risk of electrical shock, turn power OFF and disconnect polarized plug from electrical outlet BEFORE performing maintenance or troubleshooting checks.

THIS APPLIANCE HAS A POLARIZED PLUG

To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a proper outlet. Do not change the plug in any way.

2

Thanks for buying a BISSELL® vacuum!
We love to clean and we’re excited to share one of our innovative products with you. We want your vacuum to work like new for the years to come, so this guide has tips on how to use, maintain and, if there’s a problem, troubleshoot.

What’s in the Box?

Dusting Brush            User Guide         Crevice Tool  stored inside Extension Wand
                 

Lower Cord Wrap             Hose

Extension Wand

2 Screws taped to handle        TurboBrush® Tool

3

Product View

1. Upper Handle
2. TurboBrush® Tool
3. Tank Release Button
4. Carry Handle
5. Washable
   Pre-Motor Filter
6. Dirt Tank
7. Dirt Tank Empty Button
8. Washable Post-Motor Filter
9. Dusting Brush
10. Cord Hook
11. Hose Clip
12. Upper Quick Wrap Release™ Cord Wrap
13. Crevice Tool
14. Power Cord
15. Extension Wand
16. Lower Cord Wrap
17. Hose Wand
18. Power Switch Pedal
19. Handle Recline Pedal
20. Foot Hose
21. Product Rating Label & Serial Number

4

Assembly

WARNING
Do not plug in your vacuum until you are familiar with all instructions and operating procedures.

1

First, place the Upper Handle onto the base and push it down. Then attach the handle with the 2 screws that are taped to the handle in a plastic bag.

2

Next, insert the Lower Cord Wrap and turn it to the left to lock it into place.

3

Then wrap the Power Cord around the cord release clips and clip the end of the plug to the Power Cord.

4

Next, insert the end of the hose into the back of the vacuum and twist to lock it into place.

5

Now wrap the hose through the Hose Clip and connect the Hose Wand to the Foot Hose down at the bottom of the vacuum.

6

Put your accessory tools on the vacuum and you’re ready to go!

Extension Wand             Dusting Brush               TurboBrush® Tool
(with Crevice Tool inside)

NOTE: The Crevice Tool can be found inside the Extension Wand. You can remove it to use it and put it back to store it neatly out of your way when you’re finished.

5

Using Your Vacuum

1

Press the red power switch with your foot to turn ON your vacuum. Press it again to turn your vacuum OFF when you’ve finished cleaning.

2

Press the recline pedal to lean your vacuum back for cleaning. To get even lower, press the recline pedal a second time. When you’re finished, lean it all the way back up to lock it into the upright position.

Using the Height Adjustment

You can easily raise or lower your vacuum to adjust to different flooring types. Simply turn the knob towards the desired flooring type. If your vacuum becomes too difficult to push, just move to a higher setting.

NOTE: Some frieze and berber carpets have long delicate fibers or threads that may be damaged by rotating brush. Repeated strokes in the same area may enhance this condition.

WARNING Before using your vacuum, make sure that the Dirt Tank is in locked position and that all filters, both pre and Post-Motor Filters are in place. DO NOT operate your vacuum without these filters.

WARNING
The rotating floor brush continues to rotate while tools are in use. To reduce the risk of injury from moving parts, always move the vacuum with the carry handle at the front of the unit. Always place the vacuum on the floor with the handle in the upright position when using tools. Never place your fingers under the vacuum when it is running. Never place the powerfoot on furniture or uneven surfaces. Do not place vacuum close enough to objects to pull them into rotating brush. To prevent carpet damage, do not lean on the vacuum or let the powerfoot tilt forward.

6

Using the Specialized Tools

Dusting Brush   Extension Wand   Crevice Tool   TurboBrush® Tool

Your new PowerForce™ Helix vacuum not only does a great job on your floors, it also comes with a complete set of accessory tools to make your above floor cleaning jobs easier. Just put your vacuum in the upright position, pick the accessory tool that best fits your needs and attach it to the end of your hose. You’re ready to clean base boards, curtains, upholstery and much more.

Maintaining the TurboBrush® Tool

1

Twist gray collar counter-clockwise, until slot appears then separate faceplate. Carefully remove brush, replace belt and brush if needed.

2

If paddle wheel gets dislodged, align the two clips on each side and pop into place.

3

The faceplate will not close properly if all parts are not aligned correctly.

Parts & Supplies

For Parts and Supplies, go to www.BISSELL.com and enter your model number in the search field.

7

Emptying the Dirt Tank

1

Press Tank Release Button and pull handle to lift Dirt Tank away from vacuum.

2

Holding Dirt Tank over a trash bin, press release but ton on back to open tank bottom and dump the debris.
Snap bottom back into place when empty.

Cleaning the Pre-Motor Filter

1

Press Tank Release Button and pull handle to lift Dirt Tank away from vacuum.

2

Open the Dirt Tank lid by lifting the release latch on the front.

3

Remove the Pre-Motor Filter by pulling it from the tank lid. Clean it with warm water. Once it’s clean and dry, put it back into the Dirt Tank lid.

Cleaning the Post-Motor Filter

1

With Dirt Tank removed, press filter cover release button to access Post-Motor Filter.

2

Clean all filters with mild detergent, rinse, and squeeze all excess water. Allow filters to dry completely before reinserting.

  WARNING
To reduce the risk of electrical shock, turn power OFF and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks.

  WARNING
Do not operate the vacuum with damp or wet filters, without filters in place or with the Dirt Tank missing. Allow components to dry before reassembling the Dirt Tank.

8

Cleaning the Separator

1

Press Tank Release Button and pull handle to lift Dirt Tank away from vacuum.

2

Remove the separator by twisting to the left (counter-clockwise), then pull it out through the bottom of the tank. Rinse and dry all sections of Dirt Tank with paper towel.

Replace the Brush & Belt

1

Unplug vacuum, turn over and unscrew Philips-head screws to remove bottom cover. Model 2191 has 5 screws.

2

Lift roller straight out. If the belt is not broken, remove roller from inside of the looped belt.

3

Replace Brush Roll and belt by looping the belt over motor shaft and Brush Roll. Line up the end caps and pull the brush forward into place, stretching the belt. Replace cover and screws.

Clearing a Clog

1

Remove the hose from the back of the vacuum by twisting it to the left. Remove any debris that may have gotten clogged.

2

Check the Foot Hose on the back of your vacuum down towards the bottom. If necessary, remove the screw from the Foot Hose and check for clogs.

3

Check the air passageway on the bottom of your vacuum. Remove the bottom cover and the brush. Remove any debris.

9

Troubleshooting

WARNING
To reduce the risk of electric shock, turn power OFF and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks.

10

Warranty

This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Care by E-mail or telephone as described below.

It may be necessary to obtain some of your personal information, such as a mailing address, to fulfill terms of this warranty. Any personal data will be handled pursuant to BISSELL’s Privacy Policy, which can be found online at www.BISSELL.com/privacy-policy.

Limited Two-Year Warranty
Subject to the *Exceptions and Exclusions from the Terms of the Limited Warranty, upon receipt of the product BISSELL will repair or replace (with new, refurbished, lightly used, or remanufactured components or products), at BISSELL’s option, free of charge from the date of purchase by the original purchaser, for two years, any defective or malfunctioning part.

See information below on “If your BISSELL product should require service”.

This warranty applies to product used for personal, and not commercial or rental, service. This warranty does not apply to fans or routine maintenance components such as filters, belts or brushes. Damage or malfunction caused by negligence, abuse, neglect, unauthorized repair, or any other use not in accordance with the user guide is not covered. This warranty will only be valid if the product is used in the same country in which it was sold.

BISSELL is not liable for incidental or consequential damages of any nature associated with the use of this product. BISSELL’s liability will not exceed the purchase price of the product.

Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.

*Exceptions and Exclusions from the Terms of the Limited Warranty

This warranty is exclusive and in lieu of any other warranties, either oral or written. Any implied warranties, which may arise by operation of law, including the implied warranties of merchantability and fitness for a particular purpose, are limited to the twoyear duration from the date of purchase as described above.

Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you.

NOTE: Please keep your original sales receipt. It provides proof of date of purchase in the event of a warranty claim.

Service

Please do not return this product to the store.
Other maintenance or service not included in the manual should be performed by an authorized service representative.

If your BISSELL® product should require service:
Contact BISSELL Consumer Care to locate a BISSELL Authorized Service Center in your area. If you need information about repairs or replacement parts, or if you have questions about your warranty, contact BISSELL Consumer Care.

Website:
www.BISSELL.com/service-centers

E-mail:
www.BISSELL.com/email-us

Call:
BISSELL Consumer Care
1-800-237-7691

Monday ­ Friday: 8am – 10pm ET
Saturday: 9am – 8pm ET
Sunday: 10am – 7pm ET

11

Register your product today!

Registering is quick, easy and offers you benefits over the lifetime of your product.

You’ll receive:

BISSELL® Rewards Points
Automatically earn points for discounts and free shipping on future purchases.

Faster Service
Supplying your information now saves you time should you need to contact us with questions regarding your product.

Product Support Reminders and Alerts
We’ll contact you with any important product maintenance reminders and alerts.

Special Promotions
Optional: Register your email to receive notice of offers, contests, cleaning tips, and more!

Visit www.BISSELL.com/registration!

Visit the BISSELL website: www.BISSELL.com
When contacting BISSELL, have model number of vacuum available.

Please record your Model Number: ___________________

Please record your Purchase Date: ___________________

NOTE: Please keep your original sales receipt. It provides proof of purchase date in the event of a warranty claim. See Warranty page for details.

Parts & Supplies

For Parts and Supplies, go to www.BISSELL.com and enter your model number in the search field.

Love your BISSELL® product?

Don’t keep it a secret.
Let us, and millions of others, know what you think!
Leave your star-rating on BISSELL.com

www.BISSELL.com

©2019 BISSELL Inc.
All rights reserved. Printed in China.
Part Number 162-1668 07/19 RevB
Visit our website at: www.BISSELL.com

Documents / Resources

Bissell POWERFORCE HELIX TURBO Vacuum [pdf] User Guide Bissell, 2190 SERIES, POWERFORCE, HELIX, TURBO, Vacuum

References

• BISSELL® | Vacuum Cleaner, Carpet Cleaner, Steam Cleaner and Parts
• BISSELL® | Vacuum Cleaner, Carpet Cleaner, Steam Cleaner and Parts
• Ask a Question
• Privacy Policy | BISSELL® Policies and Information
• Product Registration | Register Your BISSELL® Product
• Find a Service Center | BISSELL