Hygger Hg-998 Aquarium Heater User Manual

HG-998 Aquarium Heater
User Manual

E-mail: [email protected]
Please read this user manual carefully before using and follow strictly in accordance with the manual.

PRODUCT FEATURES

• Adjustable temperature from 68°F-93°F(20°C – 34°C) to maintain constant and stable temperatures for fresh ormarine water.
• Fully submersible heater including two suction cups for mounting in any suitable position horizontally or vertically.

INSTRUCTIONS

Before plugging the appliance into the power source, please install the appliance safely.First,refer to the recommended tank and heater size chart to choose the most suitable heater for the desired temperature.The heater will automatically operate according to the temperature setting.If it is set to 82°F, the heater will heat the water to 82°F and then will switch off when the set temperature is reached.If the heater has been working for more than 24 hours and the water temperature is 2°C more or 2°C less than the set temperature, check that:

1. The thermometer reading is accurate.
2. The power has been switched on.
3. The temperature has been set correctly.
4. The water surface is above the water level mark.
5. The water is circulating well, do not place the heater directly under the filter’s spillway. If it was unavoidable, slow down the water flow.

MAINTENANCE:

• Unplug or switch off all appliances in the aquarium before carrying out maintenance.
• Do not use detergents or other chemical cleaners.
• To clean the heater, unplug it first and then leave the heater in the tank for 15 minute and remove it from the tank. Wash the heater in clean water.
• When reinstalling the heater, select you desired location and position the heater below the minimum water level.
• This appliance has no parts that can be repaired by users.
• For indoor use only, not in the bathroom.

ATTENTION

• DO NOT power on the heater before you put it in the water, as there is a chance to get scalded.
• If you want to move the heater or change the aquarium water, you need to power off the heater first and wait until the temperature drops to normal temperature.
• It is suggested that the water level should not be lower than the hard rubber head of the heater.
• This product is not supposed to be used by children or those without independent working abilities.
• There will be a little water mist on the inner wall of the tube when heating, and it will disappear slowly after the heating is stopped. This is a normal phenomenon. The product is double-protected and has passed UL certification. It is a safe product to use.

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

WARNING:
To guard against injure, basic safety precautions must be observed, including the following:
READ AND FOLLOW ALL OF THE SAFETY
INSTRUCTIONS AND NOTICES ON THE APPLIANCE.
DANGER: To avoid possible electric shock, special care should be taken since water is employed in the use of aquariums and pond. For each of the following situations, do not attempt repairs by yourself; return the appliance to an authorized service facility for service, or discard the appliance.
A. If the appliance shows any sign of abnormal water leakage, immediately unplug it from the power source.
B. Carefully examine the aquarium heater after installation. It should not be plugged in if there is water on parts not intended to be wet.
C. Do not operate any appliance if it has a damaged cord or plug, if it is malfunctioning or it has been dropped or damaged in any manner.

1. To avoid the possibility of the appliance plug or outlet getting wet, position aquarium stand and tank to one side of a wall-mounted outlet to prevent water from dripping onto the outlet or plug. A drip loop, shown in the figure above, should be arranged by the user for each cord.
2. If the plug or outlet does get wet,DO NOT unplug the cord.Disconnect the fuse or circuit breaker that supplies power to the appliance.Then unplug and examine for presence of water in the outlet.
3. If an extension cord is necessary,a cord with the proper rating should be used.A cord rated for less amperes or watts than the appliance rating may result in overheating. Care should be taken to arrange the cord so that it will not be tripped over or pulled.
4. Close supervision is necessary when any appliance is used by or near children.
5. To avoid injury,do not touch moving parts or hot parts such as heaters,reflectors,lamp bulbs or the like.
6. Always unplug an appliance from an outlet when not in use,before putting it on or taking off parts or before cleaning.Never yank the cord to pull the plug from the outlet.Grasp the plug and pull to disconnect.
7. Do not use an appliance for other than the intended use. The use of attachments not recommended or sold by the appliance manufacturer may cause an unsafe condition.
8. Do not install or store the appliance where it will be exposed to the air or to temperatures below freezing.
9. Make sure an appliance mounted on a tank is securely installed before operating it.
10. This appliance has a polarized plug(one blade is wider than the other).As a safety feature,this plug will fit into a polarized outlet only one way. If the plug does not fit fully into the outlet,reverse the plug.If it still does not fit, contact a qualified electrician.Never use with an extension cord unless the plug can be fully inserted. Do not attempt to defeat this safety feature.

PACKAGE INCLUDED:

• 1x aquarium heater
• 1 x user manual
• 2x sucker

WARRANTY:

1. 1-year free warranty.
2. 1-month free return.
3. Free replacement for 3 months.
4. Contact information:
   Website: www.hygger-online.com
   E-mail: [email protected]

https://wa.me/qr/JTMWCKJNUIMIP1

Thank you for choosing Hygger, making aquarium keeping easier one product at a time.lf you have any problems or suggestions for aquarium heater, please contact us by email before leaving feedback or opening a case, it will be the fastest way to solve your problem.
If you are satisfied with the aquarium heater, please leave positive feedback for our product, in order to let morecustomers enjoy it. Thanks again!
E-mail: [email protected]
Website: http://www.hygger-online.com

Puhui Import und Export GmbH
Birnbaumsm~hle 65
Frankfurt(Oder) 15234
Letter box: [email protected]
Telephone number: +03381-2697990
GET Product Service Ltd.
Beacon House Stokenchurch Business
Park,Ibstone Rd,Stokenchurch
High Wycombe HP14 3FE UK
[email protected]
+447419325266Made in china