Introduction to Device
Detect Screen Functions
- Detect Mode
- Sensitivity
- Frequency
- Notch Menu / Discrimination Settings
- Ground Balance Menu
- Pinpoint
- Depth Gauge
- FerroCheck
 | Global setting and it is valid for all modes. |
 | Mode-based setting and it is valid only for selected modes. |
 | This setting is valid for PARK-FIELD-BEACH modes |
 | Frequency Shift / Noise Cancelation |
 | Recovery Speed |
 | Volume |
 | Audio Settings Menu |
 | Tone Number |
 | Tone Volume |
 | Tone Pitch |
 | Tone Break |
 | Threshold Level |
 | Threshold Pitch |
 | User Profile |
 | Brightness |
 | Vibration |
 | LED Flashlight |
 | Bluetooth |
 | Clock |
 | Time Tracking |
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirements.
