AT-VMMS Vent Mount Magnetic Wireless Charger
Product Information:
The Autotech Magnetic Wireless Charging Vent Mount (AT-VMMS) is
a device that allows you to charge your phone wirelessly while
driving. The mount is equipped with a Magsafe compatible magnet
that securely holds your iPhone 12 or higher without a case. For
non-Apple phones, a ring plate is included to attach to the phone
mount. The mount can be rotated 360 degrees to provide a
comfortable viewing angle. The device complies with part 15 of the
FCC rules and also complies with FCC radiation exposure limits set
forth for an uncontrolled environment. The device is also certified
by IC CAN IECS-003/NMB-003.
Product Usage:
Follow the steps below to use the Autotech Magnetic Wireless
Charging Vent Mount:
- Press the quick release button to open the grips and lock the
mount securely to the vent. Press the button again to release the
mount. - Turn the knob to lock the phone holder in place. The mount can
turn 360 degrees, so adjust it to your preferred viewing
angle. - If you have an iPhone 12 or higher, the Magsafe compatible
magnet will securely hold your phone without a case. For non-Apple
phones, use the ring plate included and attach it to the phone
mount. - Plug one end of the cable into the port on the mount and the
other end into your car’s USB port to charge your phone
wirelessly.
Please note that during operation, a distance of 15 cm
surrounding the device and 20 cm above the top surface of the
device must be respected to comply with FCC RF radiation exposure
limits set forth for an uncontrolled environment. Additionally,
this warranty does not extend to damage or failure that results
from misuse, neglect, accidents, alteration, abuse, improper
installation, or maintenance.
ENGLISH
MAGNETIC
WIRELESS CHARGING
VENT MOUNT
AT-VMMS
ENGLISH
FCC STATEMENT:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
· Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: 1. this device may not cause harmful interference, and 2. this device must accept any interference received, including interference that may cause undesired operation. CAUTION:Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
RF Exposure Radiation Exposure Statement This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co located or operating in conjunction with any other antenna or transmitter. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected .
IC CAN IECS-003/NMB-003
ENGLISH
ENGLISH
LIMITED WARRANTY
Thank you for purchasing a Autotech product from Mizco international, Inc.
We want you to enjoy this product without any problems. However, in the unlikely event that it malfunctions, we will either repair or replace it as part of the product’s 5 year limited warranty.
If the product has malfunctioned during normal use, the responsibility of Autotech is limited solely to the repair or replacement, at its option, of the product. This warranty does not extend to damage or failure that results from misuse, neglect, accidents, alteration, abuse, improper installation or maintenance.
All brands represented herein are registered trademarks of their respective manufacturers. Design and specifications are subject to change without notice.
1. Press the quick release button to open the grips and lock the mount securely to the vent. Press button again to release.
2. Turn knob to lock the phone holder in place. The mount can turn 360 degrees.
3. Magsafe compatible magnet, securely holds your iPhone 12 or higher without a cases. For non Apple phones you can use the ring plate (included) to attach to phone mount.
4. Plug the cable into the port and the other side into your car USB to charge wireless.
©Mizco International, Inc. All rights reserved. All trade names are registered trademarks of the respective manufacturers listed. Mizco International Inc., Cranford, NJ 07016 [email protected] www.mizco.com www.toughtested.com
Home Page - Mizco | Mizco
ToughTested
