Q25 PoS Terminal
Product Information
Product Name: Q25
Version: 1.0
Release Date: April 10, 2020
End of Support Date: December 24, 2021
Model Number: 200312000000510
Product Usage Instructions
- Ensure that you have the Q25 product.
- Check the version of your Q25 product. It should be version
1.0. - The Q25 product was released on April 10, 2020. Please note
this for reference. - The Q25 product will receive support until December 24, 2021.
After this date, support will no longer be available. - Identify the model number of your Q25 product. The model number
is 200312000000510.
If you have any further questions or need assistance, please
refer to the user manual or contact our customer support.
1.0
2.0
20200410 20211224
Q25
200312000000510
Q25
1.0
2.0
20200410 20211224
Q25
200312000000510
Q25
FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. To comply with RF exposure requirements, a minimum separation distance of 20mm must be maintained between the user’s body and the handset, including the antenna.
IC STATEMENT This device complies with Industry Canada Unlicence-exempt RSS standard(s) Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction withany other antenna or transmitter.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.Ce dispositif est conforme aux normes autoriser-exemptes du Canada RSS d’industrie L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.Cet équipement est conforme avec l’exposition aux radiations IC définies pour un environnement
non contrôlé. L’utilisateur final doit respecter les instructions de fonctionnement spécifiques pour satisfaire la conformité aux expositions RF. Cet émetteur ne doit pas être co-localisées ou opérant en conjonction avec une autre antenne ou transmetteur. Ces exigences définissent
